Axxess OESWC-1761-RF Manual de instruções de instalação - Página 3

Procurar online ou descarregar pdf Manual de instruções de instalação para Peças para automóveis Axxess OESWC-1761-RF. Axxess OESWC-1761-RF 8 páginas. Axxess interface automobile parts - steering wheel user manual

Imprimir página

Wiring The OESWC Interface

1. Connect the red wire to 12 volt accessory

2. Connect the Black wire to ground (you may use the same ground that

you use for the aftermarket radio)

Setting Up The OESWC Transmitter

1. Press the Red and Green buttons simultaneously for 5 seconds, and

then press volume up for two seconds. This will orientate your button

direction.

2. Turn on the ignition and press volume up on the OESWC transmitter.

This will "marry" the transmitter to the interface.

NOTE: If you are replacing a transmitter you must turn on the ignition

and within the first 10 seconds press and hold the source button for ten

seconds. This will "marry the new transmitter.

Programming The OESWC Transmitter

1. Complete connections to the factory radio

* If this is the first time the OESWC TRANSMITTER is being installed in a

vehicle:

2. Turn the ignition on; the led will start flashing rapidly which means the

OESWC interface is looking for the vehicle. Go to step 4.

* If the OESWC TRANSMITTER was installed in a vehicle before:

2. Turn the ignition on, the led will flash once.

3. Hold down the reset button for more then 2 seconds but less then 10

seconds, the led will start flashing rapidly

4. After a couple of seconds the led should stop flashing and not light up