Epson 790 Instruções de instalação - Página 8

Procurar online ou descarregar pdf Instruções de instalação para Impressora Epson 790. Epson 790 9 páginas. Epson stylus photo printer photo 790 daily use guide
Também para Epson 790: Utilização diária (26 páginas)

Imprimir página
Epson 790 Instruções de instalação
IV. Auto Reset Procedure
13. When the indicator light on printer shows short of ink and change cartridges (Picture
A); Please turn off the printer for about 30 seconds, then switch it back on. At this
time the Ink meter bar shall show 99% (Picture B). You can start printing as usual.
(Picture A)
P.S:
the black rubber is used only in the process of transportation when the reservoir bottles
are full of ink. They are used to avoid ink leakage. In the meantime, you can use it for
propping up the lid of the printer

Notice:

1. Please don't take out cartridge at random after installing the CIS system. Keep the reservoir
bottles on the same level with the printer.
2. Try to keep at least 1/2 inch of ink in the bottles, as you don't want to run out of ink and draw
air into the cartridge.
3. Don't place the Reservoir Bottles higher or lower much than the printer.
4. To be used in a dry place between 15 and 35degree. Avoid exposure to direct sunlight.
5. Don't put the continuous ink supply systems reversed or leaning during the shipment.
Please make sure all the ink filling holes and Ventilation holes are closed tightly during the
transportation. Otherwise, the ink shall leak out.
6. Don't sway the cartridge frequently. It may cause ink leakage.
7. Don't pull out the connector of cartridge and don't tear off adhesive tape at the bottom of
cartridge.

Warning:

1. Not drinkable; keep it out reach of children.
2. Avoid exposure to direct sunshine and don't keep it in high or freezing temperature.
3. Avoid collision and fallen down.
(Picture B)