CIRCUIT DESIGN MU-1 Manual de operação - Página 3
Procurar online ou descarregar pdf Manual de operação para Interfaces USB CIRCUIT DESIGN MU-1. CIRCUIT DESIGN MU-1 17 páginas. Embedded low power radio modem mu-1/mu-1 usb interface kit
Imprimir página1.1 Outline
The MU-1 USB interface kit MU1-UIK is a development kit for planning radio system applications with a USB
interface connection function that use the embedded low power radio modem MU-1. Purchasing the kit enables you
to begin evaluating communication with the MU-1 immediately.
The MU1-UIK uses the FTDI FT8U232MB that has a protocol conversion function to convert between the USB and
UART interfaces. Since the control program created by the user accesses the host COM port, users can apply their
fund of knowledge of RS232C technology.
The on-board MU-1 can be controlled using simple dedicated commands, so that the developer can concentrate on
designing the protocols for transmitting and receiving data, without needing to be aware of control of the radio
component.
Power to the USB interface board MU1-USBIF in the kit is supplied from the USB interface, so an external power
supply is not necessary.
The MU1-UIK can be used with a variety of operating systems (Windows 98, Me, 2000, XP).
*1 Before using this product, it is first necessary to install the VCP driver. For installation, refer to the information on
installing the driver found in the setup launcher on the setup disk.
1.1.1 The MU1-USB
In this operation guide, for the sake of convenience, the MU-1 USB interface board MU1-USBIF with the
embedded low power radio modem MU-1 mounted on it is referred to as the MU1-USB. Before using the kit, mount
the MU-1 on the MU1-USBIF. When mounting the MU-1, observe the following cautions, and carry out the soldering
carefully.
MU-1
Cautions for soldering
• To prevent damage to the connectors, solder the joints quickly.
• Avoid connection defects.
Caution
• In order to prevent damage to the MU-1 and the MU1-USBIF from static electricity, ground yourself
before starting work.
• Do not cause short circuits by dripping solder on the board.
Important
It is not possible simply to replace communication using existing RS232C system equipment connected
with a cable, with MU1-USB wireless communication. The hardware and software must be designed
specifically for the MU-1.
OG_MU1-UIK_v20e
Chapter 1 The MU1-UIK
+
MU1-USBIF
=
2
OPERATION GUIDE
1
*
MU1-USB
Circuit Design, Inc.