Epson AcuLaser C4000 Referência rápida - Página 10
Procurar online ou descarregar pdf Referência rápida para Impressora Epson AcuLaser C4000. Epson AcuLaser C4000 23 páginas. High performance colour lasers
Também para Epson AcuLaser C4000: Brochura e especificações (24 páginas), Manual de configuração (48 páginas), Brochura e especificações (6 páginas)
Imprimir página
Reserve Job Canceled
The printer cannot store the data of your
print job using the Reserve Job function. The
maximum number of print jobs stored in the
printer's Hard Disk Drive has been reached,
or the drive has no more memory available
to store a new job. To store a new print job,
delete a previously stored job. Also, if you
have any Confidential Jobs stored, printing
those jobs will make more memory
available.
To clear this error, select Clear Warning
from the control panel's Reset Menu. For
instruction about accessing the control panel
menus, see "How to access the control panel
menus."
Reset
The printer's current interface has been reset
and the buffer has been cleared. However,
other interfaces are still active and retain
their settings and data.
Reset All
All printer settings have been reset to the
default configuration, or to the last settings
that were saved.
Reset to Save
A control panel menu setting was changed
while the printer was printing. Press the N
Start/Stop
button
setting will become effective after printing
has finished.
ROM Check
The printer is checking the ROM.
Self Test
The printer is performing a quick internal
check.
to clear this message. The
EPSON AcuLaser C4000 Quick Reference
Service Req xyyy
A controller error or a print engine error has
been detected. Turn off the printer. Wait at
least five seconds and then turn it back on. If
the error message still appears, write down
the error number listed on the LCD panel
(xyyy) and turn off the printer, unplug the
power cord, and contact a qualified service
representative.
Standby
The printer is in the standby mode. The
printer switches to the online mode
automatically when the printing data is sent
to the printer.
Unable Clear Error
The printer cannot clear an error message
because the error status still remains. Try
solving the problem again.
Worn Fuser
This message indicates that the fuser unit has
reached the end of its service life. Printing
after this message appears is not guaranteed.
Turn the printer off, then replace the fuser
unit with a new one. See "Fuser Unit" in the
Reference Guide for instructions.
The error clears automatically after you
replace the unit and close all printer covers.
Worn Photoconductor
This message indicates that the
photoconductor unit has reached the end of
its service life. Printing after this message
appears is not guaranteed. Turn the printer
off, then replace the photoconductor unit
with a new one. See "Photoconductor Unit"
in the Reference Guide for instructions. The
error clears automatically after you replace
the unit and close the printer covers.
(10/22)