Arch hth easiflo 1 75876 Manual do operador - Página 5
Procurar online ou descarregar pdf Manual do operador para Filtro de piscina Arch hth easiflo 1 75876. Arch hth easiflo 1 75876 11 páginas.
Imprimir página
After completing the PRE-START-UP CHECKLIST, and
establishing that all components of the chlorinator are
operating properly, your Easiflo
for start-up.
Routine maintenance of the Easiflo
minimized when proper pool water balance is
maintained. Maintain pool water chemistry as follows:
Total Alkalinity
Calcium Hardness
H
P
Adherence to these recommendations at all times will
ensure the most effective and economical performance
®
from the Easiflo
1 Chlorinator.
NOTE:
The use of CO
2
Alkalinity.
High total alkalinity (over 80 ppm) will
increase scale and solids buildup in chlorinator.
WARNING
®
Use ONLY Easiflo
Briquettes in the Chlorinator. The
use of any other treatment chemicals will void the
warranty. DANGER: Under no circumstances mix
calcium hypochlorite with other forms of concentrated
chlorine or other chemicals. Fire and/or explosion may
result. Caution must be used when refilling dispenser.
KEEP OUT OF REACH OF CHILDREN
Output Rate and Start-up Settings for
Commercial Pools and Spas Vs. Inlet
Flow Rates
Inlet Flow Rate lt / min
0.75
0.95
1.14
1.33
1.5
1.7
1.9
2.08
2.27
2.46
2.65
2.83
3.02
3.21
3.4
3.6
3.8
START-UP PROCEDURES
®
1 Chlorinator is ready
®
1 Chlorinator is
60-80ppm
200-1800ppm
7.2-7.6
to lower pH will raise Total
Av Cl kg / day Indoor or stabilised
0.22
0.72
1.00
1.50
2.00
2.50
3.10
3.40
3.80
4.00
4.40
4.70
5.20
6.00
6.50
6.80
7.00
1.
Fill the Briquette Hopper with Easiflo
The Briquette Hopper holds 12.7kg of briquettes.
2.
Open all valves to the pool and the outlet ball valve
of the chlorinator.
3.
Check the chart below to determine an
approximate start-up Inlet Flow setting for your
pool (or be certain that the Auto Controller is
calibrated and the set-points are correct). Set the
Flow Indicator at the recommended setting using
the inlet ball valve. Note: For best chlorinator
performance with an ORP controller, set the flow
indicator for a pool 30% larger than the one at your
facility. This will assist in maintaining desired Free
Available
chlorine
overshooting ORP set point.
4.
Monitor the water flow to the chlorinator daily to
ensure that a proper flow is being maintained.
5.
During the first few days of operation, check
chlorine level in the pool frequently to establish the
best Inlet Flow setting (or Auto Controller setting)
for your pool. Adjust the chlorine output either up
or down according to the table, or adjust the
chlorine setpoint.
pool (M3)
19
60
83
125
170
208
265
290
320
350
380
410
450
500
540
575
600
3
®
Briquettes.
level
in
pool
without
Outdoor pool
unstabilised (M3)
4.7
15
21
30
42
52
83
102
117
125
133
148
161
180
199
217
236