CREE LIGHTING KR8 Round Instruções de instalação Ans

Procurar online ou descarregar pdf Instruções de instalação Ans para Luz de trabalho CREE LIGHTING KR8 Round. CREE LIGHTING KR8 Round 2 páginas.

Imprimir página

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be

followed including the following:

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

DANGER- Risk of shock- Disconnect power before installation.

DANGER – Risque de choc – Couper l'alimentation avant l'installation.

This luminaire must be installed in accordance with the NEC or your local

electrical code. If you are not familiar with these codes and requirements,

consult a qualified electrician.

Ce produit doit être installé conformément à NEC ou votre code électrique

local. Si vous n'êtes pas familier avec ces codes et ces exigences, veuillez

contacter un électricien qualifié.

This luminaire is thermally protected. Do not install insulation within 3 inches

(76 mm) of luminaire sides or junction box nor above luminaire in such a

manner as to entrap heat. Ne pas mettre l'isolant a moins de 76 mm (3 po)

de toute partie du luminaire. Convient aux plafonds suspendus.

Blinking of this thermally protected luminaire may indicate overheating. Si

l'ampoule de ce luminaire a protection thermique clignote, cela peut signifier

une surchauffe.

This luminaire must be supported by main runners or other building structure

that is capable of supporting fixture weight.

SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE

TO INSTALL:

Adjustment Nut

Connection

Box

Mounting

Frame

1 of 2

Quick Mount

Brackets

Conduit Whip

Heat Sink

(2) Screws

(for Attaching

Connection Box)

Mounting

Frame

Luminaire Trim

NOTE: Mounting Frame and Luminaire Trim are

shipped separately.

MOUNTING FRAME INSTALLATION

STEP 1:

Mark the intended location of the luminaire and cut

appropriate opening in the ceiling using the chart

below:

STEP 2:

Thread rigid conduit, bar stock, wire or C-channel

(supplied by others) through quick-mount brackets

at the sides of the mounting frame. See Figure 1.

STEP 3:

Attach mounting means to structure capable of

supporting the luminaires weight.

L-Clip

STEP 4:

Adjust mounting height by loosening adjustment nut,

see Figure 1, and then position bracket so that the

bottom of the plaster ring is flush with the bottom of

the opening of the finished ceiling.

STEP 5:

Tighten adjustment nut.

LUMINAIRE TRIM INSTALLATION

STEP 1:

Locate safety cable on the mounting frame and

feed it through the mounting frame hole. Attach the

safety cable to the L-clip located on the top of the

Luminaire Trim Assembly's heat sink . See Figure 2.

KR Series

LED Architectural Downlight

INSTALLATION INSTRUCTIONS

KR SERIES

CUTOUT DIMENSIONS

KR8 Round

8.25" (21 cm)

Includes: KR8™

LPN00296X0001A0