Creek Audio A50i R Instruções de utilização
Procurar online ou descarregar pdf Instruções de utilização para Amplificador Creek Audio A50i R. Creek Audio A50i R 2 páginas.
Imprimir página
CREEK A50i and A50i R SPECIFICATION
POWER OUTPUT (both channels)
POWER OUTPUT (one channel)
POWER OUTPUT (one channel)
Not recommended for use into more than one pair of 4 Ω loudspeakers.
TOTAL HARMONIC DISTORTION
FREQUENCY RESPONSE
SLEW RATE
INPUT SENSITIVITY (passive)
SIGNAL TO NOISE RATIO ('A' weighted)
SEPARATION (line input)
MM SENSITIVITY AND IMPEDANCE (when fitted)
MC SENSITIVITY AND IMPEDANCE (when fitted)
POWER CONSUMPTION (at idle)
POWER CONSUMPTION (full power 10% THD)
WEIGHT
SIZE
MAINS VOLTAGE
@ 60Hz
@ 50Hz
MAINS VOLTAGE AND FREQUENCY IS INTERNALLY SET FOR THE COUNTRY OF USE
Creek Audio Ltd reserves the right to change or modify the specification of its products without prior warning.
Creek Audio Ltd
12 Avebury Court, Mark Road, Hemel Hempstead, HP2 7TA England
Tel:
+44 (0)1442 260146
E-mail: [email protected]
50 W into 8 Ω Ω
60 W into 8 Ω Ω
80 W into 4 Ω Ω
< 0·05% 20 Hz to 20 kHz
3 Hz to 25 kHz - 1 dB
µ µ
> 40 V per
S
450 mV
> 100 dB
> 60 dB at 1 kHz
3.5 mV 47kΩ Ω
0.75 mV 1kΩ Ω
< 45 W
260 W
6 kg, 13.2 lbs
430 x 65 x 250 mm
17" x 2·75" x 10''
100V Japan, 115V North America
230/240V Europe, Asia and UK
Designed and made in the UK.
Fax:
+44 (0)1442 243766
Internet: www.creekaudio.com
Creek A50i
& A50i
Operating Instructions
Thank you for purchasing the A50i amplifier.
You are now in possession of a State of the Art Integrated Amplifier. The functions and
operation of the A50i are extremely simple. However, the following notes are provided
to explain all aspects of its design and use. These instructions apply to both the
standard and remote versions of the A50i.
MAINS CONNECTION
When unpacking the amplifier please keep the packing material in a safe place for
possible future use. In the pack there is a separate mains cable with a moulded plug
suitable for connecting to the mains supply in the country of use. The IEC socket end
of the cable should be firmly inserted into the connector on the rear panel marked
"Mains Input".
The high quality performance of the amplifier will be impaired if the electrical supply to
it is in poor condition. If in doubt, consult a qualified electrician or your supplying
dealer. The "Mains Input" connection is also fitted with a fuse, specifically suited to the
supply voltage of the country of use. The correct value is clearly marked on the rear
panel next to the Mains Input.
Should it be necessary to replace the fuse, ensure that you use the same type as
specified on the rear panel:
i.e: 5 x 20mm cartridge type T 2A surge resisting for 220-240V 50Hz AC, T 4A
surge resisting for 110-120V 60Hz AC.
R