Creek Audio CD43 mk 2 Manual de Instruções - Página 8
Procurar online ou descarregar pdf Manual de Instruções para Leitor de CD Creek Audio CD43 mk 2. Creek Audio CD43 mk 2 17 páginas. Creek audio cd player operating instructions cd43 mk 2
Imprimir páginaCD43 mk2
REMOVING THE DISC
The disc tray can be opened at any time by
pressing the O P E N / C L O S E button.
Remove the disc only after the tray has
fully opened.
CAUTION
u Do not put anything except a Compact Disc
into the tray. Foreign objects can damage
the mechanism. DVD's will not play.
C O N T R O L A N D O P E R ATION
This section describes the CD player's controls in the order in which you would normally use them.
Follow the instructions step-by-step and you will easily master the operation of the unit.
P O W E R
The CD43 mk2 is equipped with a mains
On/Off switch on the rear panel next to the
power cord. The marking on the panel
clearly shows that 1 is on and 0 is off.
Switching on the power from the rear panel
automatically places the CD43 mk2 in
Standby mode. To wake it up, press the
S TANDBY button on the front panel or
STBY on the remote handset. The LED
indicator will alternate from yellow colour in
Standby mode to green when ready to
play. The display will also illuminate when
ready to play. If the drawer is open, it will
close automatically when Standby is
pressed.
To wake up the CD43 mk2, press any
button. However, the disc drawer can be
opened immediately from Standby.
N O R M A L DISC PLAY
Before playing a disc, check the player's
power cable and output cable connections.
1. Switch on the CD43 mk2 at the rear panel,
a yellow LED will light above the power
button.
2. Press the STANDBY switch on. The LED
will turn green.
3. Press the OPEN/CLOSE or DISC button to
open the disc tray and load the disc.
4. Press the OPEN/CLOSE or DISC button
8
Compact Disc Player
u Do not force the tray by hand during the
opening and closing operations.
u To avoid dirt and dust entering the
mechanism, keep the disc tray closed
when the CD player is not in use.
u Never load two discs into the disc tray.
again to close the disc tray.
N.B. If you get a message
display when the disc tray is fully closed,
this means that the disc is improperly
loaded (most likely upside down). To
check, open the disc tray again and reload
the disc correctly.
If the disc tray gets jammed while closing,
the tray will stop and open automatically. If
this happens check the disc tray and reload
the disc correctly.
5. When the disc is loaded correctly the the
player will spin the disc to read the TOC
(table of contents). This will tell the player
how many tracks are recorded on the disc
and how long they are. Depending on the
number of tracks and the method of
recording the information, the TOC read
can vary from 3 - 10 seconds or more. Until
this has been achieved, no other function
will work. When the TOC is correctly read
the player will display the information.
For example:
There are 8 tracks on the disc. The total
playing time is 48 minutes and 54 seconds.
The player is set to play when required.
6. Press the PLAY button. The PLAY symbol
will appear on the display. The disc will start
on the
dISC