Archon RTB16-SB Instruções de instalação, operação e manutenção - Página 3

Procurar online ou descarregar pdf Instruções de instalação, operação e manutenção para Pulverizador de tinta Archon RTB16-SB. Archon RTB16-SB 4 páginas.

Imprimir página

MAINTENANCE

With proper care, your Model RTB16 spray gun will give you reliable service. To maintain performance,

parts should be inspected regularly and replaced when necessary with genuine ARCHON parts.

DISASSEMBLY PROCEDURE

If it becomes necessary to disassemble this unit,

follow these steps:

1. Make sure water supply valve is off.

2. Release all the pressure and liquid from the

hose to RTB16 spray gun by operating trigger

unit until water ceases to flow.

3. Disconnect the RTB16 spray gun from the

supply connection.

4. Remove RUBBER COVER (5) by pulling on

its back end until it clears the BODY (1). Then

pull the front of the RUBBER COVER forward

until it clears the BODY. Now, slide the cover

down the BODY until free.

5. Next, remove HANDLE (9) by removing

HANDLE BUSHING (6), BODY BUSHING (7),

and HEX HD. SCREW (8).

6. Now, unscrew and remove FRONT BODY

BUSHING (2) and O-RING (4).

7. The STEM ASSEMBLY (3) can now be

removed by pulling it straight out the front of

the spray gun body.

8. Your RTB16 spray gun is now disassembled.

Original replacement parts can be purchased

directly from ARCHON Industries.

A detailed assembly drawing can be found on the following page

ITEM NO.

PART NO.

RTB16-01

RTB16-18

RTB16-27

STEM ASSEMBLY, RTB16 SPRAY GUN

56018-003

RTB16-17

RUBBER COVER, RTB16 SPRAY GUN

RTB16-25

HANDLE BUSHING, RTB16 SPRAY GUN

RTB16-26

BODY BUSHING, RTB16 SPRAY GUN

RT12-22-375

RTB16-06

ASSEMBLY PROCEDURE

Before reassembling the RTB16 spray gun apply

a moisture resistant valve lubricant such as Dow

Corning MOLYKOTE 111 to all O-ring seals.

Sliding metal surface should be lubricated with

Logix Thread Smart Anti-Seize compound.

When reassembling the RTB16 spray gun, apply

LOCTITE 243 to FRONT BODY BUSHING (2),

and HEX HD. SCREW (8).

1. Check that BODY (1) is clean and ready for

assembly.

2. Insert STEM ASSEMBLY (3) into BODY (1)

until it is fully seated. Make sure all seals are

undamaged, properly lubricated and intact.

3. Applying careful pressure to compress the

spring, screw FRONT BODY BUSHING (2)

with O-RING (4) into BODY (1).

4. Assemble HANDLE (9) with HANDLE

BUSHING (6), BODY BUSHING (7) and HEX

HD. SCREW (8).

5. Install RUBBER COVER (5) by first inserting

the BODY (1) handle into the cover. Slide on

cover until it is close to body. Now stretch the

rubber cover over the front of BODY (1) and

then over rear of BODY (1) until in place.

6. Test the assembled spray gun to ensure that

it operates correctly.

PARTS LIST

DESCRIPTION

BODY, RTB16 SPRAY GUN

FRONT BODY BUSHING, RTB16

O-RING, #2-018, BUNA

HEX HD. SCREW 10-32, RTB16

HANDLE, SS, RTB16 SPRAY GUN

QTY.