Creo iQsmart 2 Adenda ao Manual do Utilizador - Página 15

Procurar online ou descarregar pdf Adenda ao Manual do Utilizador para Scanner Creo iQsmart 2. Creo iQsmart 2 16 páginas.

Direct Mount

Originals are mounted in the scanner by placing them directly on the

Base glass. You can mount one original for single preview or several

originals for multi-preview.

For single preview:

•

Tape the original to the Base glass, placing the top right corner

of the original near the 0,0 corner of the glass (lower right corner).

Place transparencies with emulsion side down, and reflectives with

image side down.

•

It is recommended that if your original is a non-standard format,

you should note the size of the original by checking the vertical

and horizontal scales of the glass. This is important when using the

Layout display window.

For more information, refer to Performing Basic Scan on page 53.

When scanning a thick reflective such as a book, it is possible to scan with

the Top door open.

For high enlargements, we recommend you to use oil when mounting

originals. For more information, refer to Oil Mounting on page 167.

For multi-preview:

In multi-preview, all originals are taped to the Base glass and scanned

in a single run. The originals must be of the same type (transparency or

reflective), but may be of different sizes and media (positive and

negative).

•

Tape the first original near the 0,0 corner of the glass, same as for

single preview (see above).

•

Tape the other originals proceeding toward the lower left corner of

the Base glass, making sure the originals do not overlap. If

necessary, continue to the next row. It is recommended to place the

originals in an orderly way, and not spread them randomly all over

the board.

Chapter 2 Preparation