Digilin Vega Manual do utilizador - Página 4

Procurar online ou descarregar pdf Manual do utilizador para Equipamento de iluminação Digilin Vega. Digilin Vega 4 páginas. Fibre optic lightsource

Imprimir página
Vega - Fibre Optic Lightsource
User Manual
1.0 - 11 August 2021
Fibre
1.
Loosen the locking screw so it no longer
protrudes into the fibre optic port.
2.
Slide the fibre optic common end into the
fibre port.
3.
Tighten the locking screw to secure the
common end in place.
Wiring
Unit is supplied with a 24VDC supply.
1.
Connect jack into socket on rear of
lightsource.
2.
Plug the power supply into electrical
supply. Power indicator should now
illuminate.
Operation
Units begins operating once power is properly
connected.
Dimming
Light level can be manually dimmed using the knob on the rear of the lightsource.
Scintillation Wheel Speed
Motor rotation speed can be manually adjusted using the knob on the rear of the lightsource. Adjustment
range is from stopped to approximately 4RPM.
Appendix A – Troubleshooting
Unit is dead – no light output and
LED power indicator on PSU is not
illuminated
Unit is dead – no light output and
LED power indicator on PSU is
illuminated, but LED indicator on
Light source not illuminated
Poor light output on fibre
Unit is dead – no light output but
LED power indicator is illuminated
digilin.com.au
+617 3899 1267
P r o b l e m
P r o b a b l e C a u s e
Mains supply off
Loose mains plug
PSU failed
PSU failed
Lightsource dimmed
LED driver failure
Dimming control at minimum
LED array or drive failure
Power Jack
Power Indicator
R e m e d y
Check supply & reinstate
Check plugs
Replace PSU
Replace PSU
Check and increase dimmer settings
as appropriate
Replace light source
Adjust brightness on dimmer control
at rear
Replace light source
Page 4 of 4