Digilin Colour Theme 3 Manual do utilizador - Página 4

Procurar online ou descarregar pdf Manual do utilizador para Controlador Digilin Colour Theme 3. Digilin Colour Theme 3 8 páginas. Tuneable white dmx controller

Imprimir página

C o lo u r T h e m e 3 - T u n e a b le W h i te D M X C o n tro lle r

U s e r M a n u a l

5 .2 - 3 N o v e m b e r 2 0 1 6

Mounting

The Colour Theme Controller is housed in a standard Clipsal plate, and as such is compatible with any

standard mounting boxes or clips. There is also a mounting frame (Clipsal Part number 4000VH1)

available in 5 colours that can be used to cover the black base and compliment wall colour.

To install the Colour Theme Controller

Remove the knob by gently pulling it straight back

2. Remove the fascia by inserting a small flat blade screwdriver into the slots on the top and

bottom of the plate and lever it off.

3. Mount to wall using appropriate hardware.

4. Re-attach fascia by pushing it into place at the top then at the bottom.

5. Re-install the knob by gently sliding it onto the shaft.

DMX Output Format

The DMX output of the Tuneable White version of the Colour Theme Controller is specifically

formatted to control the LDMX-PWM-2. The data is as per the table below.

D M X C h a n n e l

Operation

Software Version

On power up, the Colour Theme Controller will briefly display 2 codes. First it will briefly display -2-,

indicating that this is a 2 channel Colour Theme. Next it will display the firmware version.

Dimming

The tuneable white version of the Colour Theme Controller allows the light level to be dimmed

from 100% to off in 5% steps. This is done by turning the knob

anti-clockwise to decrease it). The display will show the current dim level until dimmed to off, at

which point the display will turn off.

Setting the Colour Temperature

To alter the colour temperature of the connected fittings, press the knob on the Colour Theme

Controller for 0.5 seconds. The display will change to show the approximate colour temperature

(presuming the standard bins of VariWhite LED strip are connected) in kiloKelvin (ie 3000K would

should show as 3.00 on the display). The value can now be altered rotating the knob (clockwise will

make the light cooler, anti-clockwise warmer).

Switching Drivers Off

To turn off the LED light fittings, simply give a short press to the knob (less than 0.5 seconds). The

unit will then display OFF for a period of 10 seconds before the display goes blank.

While the Colour Theme Controller is off, any show running is paused. To turn the light fittings back

on, simply press the knob or turn it clockwise to increase the dim level.

D a ta

Sets the ratio of warm to cool white from 0 (100% warm white)

Colour Temperature

Sets the brightness level of the connected LED fitting from

Dim Level

N o t e s

to 255 (100% cool white).

100% (DMX 255) to off (DMX 0).

(clockwise to increase dim level,

P a g e 4 o f 8