Cres Cor HC1-UA-11 Manual de Instruções de Operação e Manutenção - Página 4

Procurar online ou descarregar pdf Manual de Instruções de Operação e Manutenção para Aquecedor de alimentos Cres Cor HC1-UA-11. Cres Cor HC1-UA-11 8 páginas.

Imprimir página

Holding Cabinet

Rev. 1 (07/15)

HC1-UA-11 FOR PROPANE CYLINDER

INSTALLATION:

WARNING

for use with natural gas. It is not user-

convertible to natural gas.

1 . Only use a 1 lb . standard cylinder marked

"PROPANE" . A larger tank can be used with an

adapter (optional accessory part number 0904-026-K

See installation FL-2362) .

2 . The cylinder must be constructed and marked in

accordance with the specifications for propane

cylinders of the U .S . Department of Transportation

(DOT) or CAN/CSA B339 .

3 . The Cylinder should not be allowed to remain in a

high heat area, such as a car, truck or direct sunlight .

DO NOT store at temperatures above 120°F (49° C)

and in unauthorized storage areas not intended for

cylinder storage .

4 . Hold and use the cylinder in an upright position and

only use when temperatures are above 10°F (-12° C).

Do not attach near flames, pilot lights or sparks.

5 . Propane Tank Hook-up:

a. Make sure the gas valve is in the "OFF" position.

b . Uncap the cylinder, hold upright and insert it in the

right rear compartment of the cabinet . Hand screw

and tighten the cylinder to the gas regulator . DO

NOT over-tighten.

Check for leaks at the connection: Spray soapy water

onto the connection and look for bubbles . Tighten more if

needed .

6 . Disconnect the cylinder when not in use . Replace the

cylinder cap when storing .

Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com

FL-2387

Page 4 of 8

INSTALLATION INSTRUCTIONS

This cabinet is

not intended

5925 Heisley Road • Mentor, OH 44060-1833

GENERAL INSTALLATION:

1 . Remove all paper and packing materials from the

inside of the cabinet and install angles into posts .

2 . Remove protective paper and vinyl material from

the outside of the cabinet .

3 . Place the cabinet in a well-ventilated area on level

floor or ground.

4 . DO NOT block the flue vent located at the upper

rear of the cabinet .

5 . Lock the two front casters before starting up or

plugging in the cabinet .

HOW TO INSTALL ANGLES:

1 . Insert end tabs of the angles into the post slots

and push down .

2 . Note the location shown in the diagram of the

18" x 26" pan slide and the 12" x 20" pan slide

DETAIL A

18" X 26" BUN PAN

12" X 20"

STEAM TABLE PAN