Cres Cor Tri-Powered Series Manual de instruções de operação e manutenção - Página 6
Procurar online ou descarregar pdf Manual de instruções de operação e manutenção para Aquecedor de alimentos Cres Cor Tri-Powered Series. Cres Cor Tri-Powered Series 12 páginas. Hot cabinets
Imprimir páginaHolding Cabinet
Rev. 4 (10/13)
Page 6 of 12
HOW TO HOLD FOOD:
WARNING
FIRST TIME START-UP:
1 . Push the POWER switch to "ELECTRIC", and
run the unit for one hour at 200°F.
NOTE: DO NOT PUT FOOD INTO CABINET!
This step is to burn off manufacturing oils and excess
adhesive.
2 . Let the cabinet cool and wipe inside clean with
detergent and hot water before first use.
USING ACCESSORY SOLAR PANEL (Optional):
The solar panel is used to increase the time between battery charges when using the cabinet unplugged in gas
mode . To use the solar system, ensure the solar panel cord is plugged into the solar jack, located in the top right
corner of the back panel of the unit . Rotate the cabinet and/or tilt the solar panel in order to catch the sunlight .
The best possible condition for solar charging is when the sunrays hit the panel straight on at 90° angle.
NOTE: It is recommended to keep the solar panel plugged in even when not in use. It will safely maintain the
battery at full charge for an unlimited amount of time if not placed in a dark area . The solar system is
not powerful enough to charge the battery from fully drained status in any reasonable amount of time .
If the battery is fully dead, plug the cabinet in to a grounded 120V outlet to charge .
FL-2361
OPERATING INSTRUCTIONS
"ON-OFF" SWITCH
Figure 1: CONTROL PANEL
CONTROL PANEL
Air is VERY HOT
when door is opened.
5925 Heisley Road • Mentor, OH 44060-1833
TEMPERATURE
CONTROL
HOW TO HOLD:
1 . Push POWER switch on to "GAS" or "ELECTRIC" .
2 . Push the "SET" button on the TEMPERATURE
CONTROL . The TEMPERATURE DISPLAY will
show "SP1" (set point 1) .
3 . Press "SET" again and the current set point temperature
will be displayed .
4 . Press the ADJUST buttons to adjust to the
desired temperature .
5 . Press "SET" to save the temperature setting.
6 . Preheat cabinet for 45 minutes .
7 . Put product into cabinet .
NOTE: Proper food holding temperature is
140°F/60°C or higher.
BATTERY INDICATOR
RESET LIGHT