Cres Cor 1000-CH-SK-DX Series Manual de instalação, operação e manutenção - Página 6
Procurar online ou descarregar pdf Manual de instalação, operação e manutenção para Forno Cres Cor 1000-CH-SK-DX Series. Cres Cor 1000-CH-SK-DX Series 15 páginas. Radiant smoker ovens
Imprimir páginaFL-2375
Smoker Ovens
Rev. 7 (4/18)
Page 6 of 15
-DX OVENS
Cooking:
1 . Press the COOK button .
2 . Turn the control knob to the desired cooking
temperature between 180°F (82°C) and 350°F (176°C) .
3 . Push the knob to set the temperature .
4 . The control automatically switches to allow you to set
HOLD temp . (Continue to step 1 below) .
Holding:
(To use as holding cabinet only, skip steps 1-4 above and
press HOLD button . Complete steps 1-3 below .)
1 . Turn the control knob to the desired holding
temperature between 135° (57°C) and 220°F (104°C) .
2 . Push the knob to set the temperature .
3 . The control automatically switches to allow you to set
cook time .
If cooking with timer, continue to step 1 below. If
cooking with food probe, skip to section "Cooking with
Food Probe".
Cooking with Timer:
1 . Turn the control knob to the desired hours/minutes .
Oven will switch from COOK to HOLD mode when
this time is done .
2 . Push the knob to set the time .
3 . Oven will switch to PREHEAT mode and control will
display "PrEHt" .
Cooking with Food Probe:
NOTE: Make sure probe was plugged in after step 1
of Holding above . If not, press the PROBE button and
continue to next step below .
1 . Turn the control knob to the desired temperature . The
oven will switch from COOK to HOLD mode when the
probe reaches this temp .
2 . Push the knob to set the temperature .
3 . Oven will switch to PREHEAT mode and control will
display "PrEHt" .
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
OPERATING INSTRUCTIONS (continued)
5925 Heisley Road • Mentor, OH 44060-1833
Running the Cycle:
1 . The control will flash "PUSH StArt" after the cabinet
has preheated to the set temp and the alarm will sound .
NOTE: A short beep will occur every 90 seconds as
a reminder. This can be turned off in the user menu by
holding the knob and the TIME buttons together for 5
seconds, then scrolling to "PSrE", changing "y" to "n",
scrolling to "End", and pushing the knob to set .
2 . Load foods into oven, insert probe (if applicable) and
close the door .
3 . Push the START button to begin the Retherm/Cook
process .
a . If cooking with timer, display will alternate between
the setpoint temperature and the countdown of the
timer .
b . If cooking with probe, display will show the
probe temp .
4 . The alarm will sound after the time is done and the
oven will switch back into HOLD mode . The timer will
now count up, showing how long the food has been
holding .
NOTE: At any time, the CANCEL button can be
pushed to return the oven back to HOLD mode at the
previous set temperature .
The DISPLAY button shows (cycles through) all the
values when in each mode:
- "PrEHt" or "PUSH StArt": Momentarily shows
actual oven temperature .
- "COOK (timed)": Shows home screen, set point,
count down time, actual oven temperature .
- "COOK (probe)": Shows home screen, set point,
count up time, actual oven temperature .
- "HOLD": Shows home screen, set point, count up
time, actual oven temperature .