Digilock DCR1-ATV1 Manual do produto - Página 2

Procurar online ou descarregar pdf Manual do produto para Fechaduras Digilock DCR1-ATV1. Digilock DCR1-ATV1 4 páginas. Rfid cam locks advanced security, shared use

Imprimir página
Programming Instructions
Initial Setup
New locks operate only with `
a.
Touch the Programming Key to the key slot until a two-tone beep is heard and the LED turns on.
b.
Touch each Manager Key to the key slot. A two-tone beep will be heard for each Manager Key that is
successfully registered.
c.
Touch the Programming Key to the key slot until a two-tone beep is heard and the LED turns off.
d.
Repeat above steps for each lock or follow Express Register instructions to setup all locks.
Express Register
Manager Key(s) can be quickly registered to multiple locks. The Programming Key copies the registered Manager Key(s) from one
lock to multiple locks.
a.
Go to the lock registered with the Manager Key(s).
b.
Press and hold ` for 10 seconds. After 5 seconds, a two-tone beep will be heard and the LED will start to flash; continue to
hold until two-sets of two-tone beeps are heard.
c.
Touch the Programming Key to the key slot until a two-tone beep is heard and the LED turns off.
d.
At each lock to be registered, touch the Programming Key to the key slot until a two-tone beep is heard and the LED flashes
once to indicate successful registration.
e.
End express registration.* Go to any registered lock and press ` then touch the Programming Key to the key slot to operate
the lock.
*The Programming Key will continue to function in express registration mode until it is used to operate a lock.
Register/Add Manager Key(s)
Up to 25 Manager Keys may be registered to a lock. If required, contact your Digilock Product Representative to order additional
Manager Key(s).
a.
Go to a lock requiring Manager Key(s).
b.
Press and hold ` for 5 seconds until a two-tone beep is heard and the LED starts to flash.
c.
Touch the Programming Key to the key slot until a two-tone beep is heard and the LED turns on.
d.
Touch each Manager Key to the key slot. A two-tone beep will be heard for each Manager Key that is
successfully registered.
e.
Touch the Programming Key to the key slot until a two-tone beep is heard and the LED turns off.
f.
Repeat above steps for each lock or follow Express Register instructions to register the same Manager Key(s) to
multiple locks.
Product Guide
RFID Cam Locks Advanced Security
.
Locks must be setup to allow full operation.
Shared Use
DCR1-ATV1
Phone: 707 766 6000
www.digilock.com | [email protected]