crescendo BASS CLEF series Manual de instruções - Página 5
Procurar online ou descarregar pdf Manual de instruções para Amplificador crescendo BASS CLEF series. crescendo BASS CLEF series 9 páginas. Encore-4.5k
Imprimir página
+12V
(B+
), GND, REM Connection
(ENCORE-4.5K)
SINGLE CONNECTION
GND
POWER INPUT
BASS CLEF series
ENCORE-4.5K
Remote turn on
HEAD UNIT
DAISY CHAIN (LINKED) CONNECTION
GND
POWER INPUT
BASS CLEF series
ENCORE-4.5K
Remote turn on
HEAD UNIT
GND
POWER INPUT
BASS CLEF series
ENCORE-4.5K
Remote turn on
Keep GROUND of equal length. This drawing is for illustration purpose only.
We recommend using 12 AWG speaker cables to obtain intended performance.
Run 12 AWG speaker cables from your speakers to the amplifier's mounting location
Keep the speaker cables separate from the power cables and and the amplifier's input cables.
Use grommets where the cables have to penetrate the vehicle chassis.
Connect the speaker wires according to the terminals on each speaker.
Strip 1cm, 3/8" of insulation of the end of each cable and twist the cables strands together tightly.
Make sure there are no stray strands that might touch other cables or terminals and cause short circuit.
Connect the cable ends to the amplifier as shown in the speaker wiring diagram.
+POWER
+POWER
GND
REM
Recommended Fuse Rating
+POWER
+POWER
REM
GND
Recommended Fuse Rating
+POWER
+POWER
REM
GND
CAUTION
5
* Keep ground as short as possible,
no longer than 20" (50 cm).
POWER INPUT
(See page 12)
* Keep ground as short as possible,
no longer than 20" (50 cm).
POWER INPUT
(See page 12)
POWER INPUT
GROUND
BATTERY
GROUND
BATTERY