AccuScreens Projection Screen Manual de instruções de instalação e funcionamento - Página 2

Procurar online ou descarregar pdf Manual de instruções de instalação e funcionamento para Ecrã de projeção AccuScreens Projection Screen. AccuScreens Projection Screen 12 páginas. Automatic/electric wall/ceiling projection screens—110-120v ac
Também para AccuScreens Projection Screen: Manual de Instruções (8 páginas)

Imprimir página

Care in mounting and in correct operation will mean a long and satisfactory life

for your ceiling screen. Locate the screen where the audience can best see it

and where other furnishings in the room permit. Mount the screen so that bot-

tom of picture surface, when fully extended, will be above heads of viewers.

BUILT-IN HANGERS

Wall screen may be mounted on wall, map

rails, suspended from ceiling or extension

brackets. Wall screens must be mounted

level and with the case-back parallel to the

wall.

FOR WALL MOUNTING

Use the keyhole slot at

the back of the hanging

bracket for flush wall

suspension. Position

screws or other fasteners

into wall and hang screen

by using slots.

FOR MAP RAIL MOUNTING

Use keyhole slots in flat brackets. Do not

use "D" rings.

FOR CEILING SUSPENSION

If the screen is to be ceiling mounted two

screw hooks placed in beam or other

solid surface will do the job. For dropped

ceilings a T-Bar Scissors Clip may be

purchased.

NOTE: Whichever method is used, the

screen should be free to swing forward

and back and not

be anchored rigidly.

Mount the screen so

that bottom of picture

surface, when fully ex-

tended, will be above

heads of viewers.

INSTALLATION

OPERATING

INSTRUCTIONS TO LOWER

PICTURE SURFACE

Pull screen down all the way.

HESITATE – then allow screen

to retract VERY SLOWLY

until it locks in place.

TO RAISE PICTURE

SURFACE

Pull down on the pull bail, then

raise quickly, as a window

shade. Keep control of the

picture surface. Do not allow

it to roll uncontrolled into the

case, or damage may result.

Caution: Allowing the screen

to return too quickly into the

protective case may cause the

handle to hit the frame. Please

pull the handle with care and

reduce the speed to avoid

damaging the other parts.