Accusplit Eagle 1020 Instruções de utilização
Procurar online ou descarregar pdf Instruções de utilização para Pedómetro Accusplit Eagle 1020. Accusplit Eagle 1020 1 páginas. Accusplit pedometer operating instructions
Imprimir páginaCongratulations on taking the first step to wellness with your purchase of an
ACCUSPLIT pedometer. It's easy to set up your new pedometer.
WEARING YOUR PEDOMETER
While gently holding the belt clip open, slide the pedometer
onto your belt or the top edge of your pants or skirt. It should fit
snugly and level, above one knee.
Note: The pedometer should be as vertical as possible. Walkers
with larger stomachs may find it helpful to wear the pedometer
farther back on the body, toward one hip.
To avoid losing or dropping your pedometer, use the included
leash and clip to fasten the pedometer securely to your clothing.
Attaching the Leash: Attach the pedometer to the leash by
looping the leash around the pedometer belt clip. Next, clasp
the waist-band of your clothing with the attached clip. You can
also use a safety pin to fasten the leash to your clothing, loop
the leash through your belt or belt loop or use a badge holder.
First, loop the
pedometer clip
Next, loop the metal
clip, then clasp clothing
Or, loop a belt or belt loop
VIEWING YOUR RESULTS
Once you put on your pedometer, it will automatically
begin to record your steps.
ACCUSPLIT, Inc. • 3090 Independence Drive, Suite 148 • Livermore, CA 94551 USA
800-935-1996 • 925-290-1900 • FAX 925-290-1930 • www.ACCUSPLIT.com • [email protected]
ACCUSPLIT®
EAGLE
OPERATING INSTRUCTIONS
Just follow the steps below, and start walking!
Or, loop a
badge holder, then
put into pocket
(Badge holder
not included)
1020
™
ACCUSPLIT
EAGLE 1020
RESETTING YOUR PEDOMETER
Most people prefer to reset step counts daily. To reset:
Press RESET button to reset to zero.
REPLACING THE BATTERY
When the display starts to dim or goes blank, it is time to
replace the battery. Your pedometer uses one Type L1142
(LR43) 1.5 volt silver oxide battery. To replace:
1. Using a jeweler's screwdriver or fingernail, gently pry
battery cover from case, using slot at top of cover.
2. Pull the old battery gently out of its holder. Replace it with
a new battery. The battery's positive (+) terminal should be
FACE UP while you put it into the pedometer.
3. Slide bottom of battery cover back into place, then snap
top of cover back into place.
NO-PROOF-OF-PURCHASE LIMITED WARRANTY
See label on back of unit for details, or check
http://support.ACCUSPLIT.com
REGISTER NOW
Please return
your AE1020 Registration to the
Repair Center address in the
warranty, and we will let you
know about future products.
STEPS
RESET
Email (preferred)
User
970-060