Diginet LEDsmart+ MMDM RT Manual - Página 6

Procurar online ou descarregar pdf Manual para Regulador de fluxo luminoso Diginet LEDsmart+ MMDM RT. Diginet LEDsmart+ MMDM RT 12 páginas. Setup functions

Imprimir página

D: Setting the Kick Start Feature

The 'kick-start' feature is only required to be enabled when dimming loads such as compact fluorescent lamps. These

lamps require the dimmer output to be set to 50% for 0.2 of a second when the lamp is turned on. This ensures the

lamp strikes successfully. The result is a short bright 'blink' when a compact florescent lamp turns on.

As the bright blink caused by the kick start feature can be undesirable for the user, it is highly recommended that

this feature remains disabled (the default) when using LED's and other light sources which do not require the kick-

start to operate.

By default Kick Start Mode is disabled. To enable Kick Start Mode, follow the steps below.

Step 1

Enter into the dimmer Setup Mode - See PART A

Step 2

Click the dimmer rotary shaft four times

Step 3

LED will blink 4 times

If Kick start is currently Disabled, lamp(s) connected to the dimmer will now turn OFF

If Kick start is currently Enabled, lamp(s) connected to the dimmer will now turn ON

Note: To cancel/exit do nothing for 30 seconds

Note: If more than one dimmer is connected to the same load, all dimmers connected

to this load will now blink 4 times

Step 4

To Enable Kick Start Mode

Adjust the dial Clockwise until lamp(s) turn ON

To Disable Kick Start Mode (Default)

Adjust dial Anti-Clockwise until lamp(s) turn OFF

Note: To cancel/exit do nothing for 30 seconds

Step 5

Click once to save & exit

Note: If more than one LEDsmart

brightness levels only needs to be set in one device. The setting is automatically saved

to all other devices connected in parallel

device is connected in parallel, the minimum

Setup Functions - Rotary Dimmer/Switch