Cisco 200E Series Manual de início rápido - Página 7

Procurar online ou descarregar pdf Manual de início rápido para Interruptor Cisco 200E Series. Cisco 200E Series 13 páginas. Advanced smart switches

Make sure that any configuration changes made are saved

AUTION

before exiting.

You are now ready to configure the switch. Refer to the

Business Advanced Smart Switch Command Reference Guide

information.

Next Steps

The following optional tasks can be accomplished by using the

procedures in the Cisco Small Business Advanced Smart Switch

Administration Guide.

•

If you are not using DHCP on your network, set the connection

type on the advanced smart switch to Static and change the

static IP address and subnet mask to match your network

topology.

•

Save your settings

•

Return your computer to its original settings

If you cannot access your switch from the web-based interface, the switch

may not be reachable from your computer. You can test network

connections by using ping, for example, on a computer running Windows:

Open a command window by using Start > Run and enter cmd.

TEP

At the Command window prompt enter ping and the advanced

TEP

smart switch IP address. For example ping 192. 1 68. 1 .254 (the

default static IP address of the advanced smart switch).

If you can reach the switch, you should get a reply similar to the

following:

Pinging 192.168.1.254 with 32 bytes of data:

Reply from 192.168.1.254: bytes=32 time<1ms TTL=128

If you cannot reach the switch, you should get a reply similar to the

following:

Pinging 192.168.1.254 with 32 bytes of data:

Request timed out.

200E Series Advanced Smart Switches

Cisco Small

for further