Cisco 2970 - Catalyst Switch Manual - Página 13
Procurar online ou descarregar pdf Manual para Interruptor Cisco 2970 - Catalyst Switch. Cisco 2970 - Catalyst Switch 19 páginas. Ios software release 12.1(14)ea1
Também para Cisco 2970 - Catalyst Switch: Boletim do produto (5 páginas), Boletim de apoio ao produto (6 páginas), Boletim de apoio ao produto (6 páginas)
Imprimir página
Cisco - Connecting a Terminal to the Console Port on Catalyst Switches
Switch
RJ45-to-RJ45
Console
Rollover Cable
(DTE)
RJ45
Signal
Pin
RTS
1¹
DTR
2
TxD
3
GND
4
GND
5
TxD
6
DSR
7
CTS
8¹
¹Pin 1 is connected internally to Pin 8.
Configuring a Terminal for Attachment to the Console or RSFC Port
Note: The console port is an asynchronous (Async) serial port; any device connected to this port must be
capable of asynchronous transmission.
Before connecting the console port, check the terminal documentation to determine the baud rate. The
baud rate of the terminal must match the default baud rate (9600 baud) of the console port. Set up the
terminal as follows:
9600 baud
8 data bits
No parity
1 stop bit
Connecting a Terminal to the Catalyst 4000
Supervisor Engine I Console Port
The console port, shown in the figure below, is a data communications equipment (DCE) DB-25
receptacle that supports a DCE EIA/TIA-232 interface. EIA/TIA-232 supports unbalanced circuits at
signal speeds up to 64 kbps.
Figure: DCE DB-25 Connector
http://www.cisco.com/warp/public/473/9.html (13 of 19) [9/4/2003 12:36:03 PM]
RJ45-to-DB25
Adapter
RJ45
DB25 Pin
Pin
8
5
7
6
6
3
5
7
4
7
3
2
2
20
1
4
Terminal
(DTE)
Signal
CTS
DSR
RxD
GND
GND
TxD
DTR
RTS