Fiap Aqua Active Profi Manual - Página 3

Procurar online ou descarregar pdf Manual para Bombas para lagos Fiap Aqua Active Profi. Fiap Aqua Active Profi 8 páginas.
Também para Fiap Aqua Active Profi: Manual (18 páginas)

Imprimir página

FIAP Aqua Active Profi

Lagern/Überwintern

Das Gerät ist frostsicher bis minus 20

C. Sollten Sie das Gerät außerhalb des Teiches lagern, führen

Sie eine gründliche Reinigung durch, prüfen Sie es auf Beschädigung und bewahren Sie es getaucht

oder befüllt auf. Den Netzstecker nicht ins Wasser tauchen!

Staubdicht, Wasserdicht bis 4 m Tiefe

Bei Frost, das Gerät deinstallieren!

Entsorgung

Das Gerät ist gemäß den nationalen gesetzlichen Bestimmungen zu entsorgen. Fragen Sie Ihren

Fachhändler.

Störung

Ursache

Gerät läuft nicht

- Netzspannung fehlt

- Laufrad blockiert

Wasserlauf

- Filterschale/Satellitenfilter

ungenügend

- Schlauch verstopft

- Schlauch geknickt

- zu hohe Verluste in den

Schlauchleitungen

Gerät schaltet nach

- Filterschale verstopft

kurzer Laufzeit ab

- Schlauch verstopft

Technische Änderungen vorbehalten. Für Druckfehler übernehmen wir keine Haftung. 01/2008

FIAP GmbH, Jakob Oswald Str. 16, 92289 Ursensollen

Tel: 09628 9213 0; Fax: 09628 9213 30;

Abhilfe

- Netzspannung überprüfen

- Reinigen

- Reinigen, evtl. ersetzen

- Schlauch prüfen, evtl. ersetzen

- Schlauchlänge auf nötiges

Minimum reduzieren

- Reinigen

www.fiap.com

FIAP Aqua Active Profi

The new innovation of FIAP. Ideal for use as filter- and watercourse pump. The advantages are that

the FIAP Aqua Active Profi pump aspirating waste particles until 10 mm over the pump cage. A surface

skimmer can additional connected on a suck connection, which is 5-tier adjustable. The regulation

follows about a ball valve mechanism. It is adjustable on the flank of the pump. We grant you 3 years

warranty for our FIAP Aqua Active line.

High lift power, low energy costs

. 2 Inlets – 1 Outlet

Skimmer connection possible 5-tier adjustable

Very high suction area (up to 10 mm waste particle over pump body)

Very good advance height

Hose connection pieces suck- an pressure side of 1" up to 1 ½"

Overwork safeguard by thermostatic switch

Cable length 10 m

3 years warranty

Information about this operating manual

Please read the operating instructions and familiarise yourself with the unit prior to using fort he first

time. Adhere to the safety information for the correct and safe use of the unit.

Intended use

FIAP Aqua Active Profi 4.500 – 30.000 series has been exclusively produced for pumping normal pond

water for filters, waterfalls and watercourses; its use is intended for water temperatures between +4

and +35

C and an operating voltage of 230 Volt. The unit is frost proof.

Use other than that intended

Danger to persons can emanate from this unit if it is not used in accordance with the intended use and

in the case of misuse. If used for purposes other than that intended, our warranty and operating permit

will become null and void

Safety information

In spite of the above, hazards for persons and assets emanate from this unit if it is used in an improper

manner or not in accordance with its intended use, or if the safety instructions are ignored.

For safety reasons, children and young persons under 16 years of age as well as persons who

cannot recognise possible danger or who are not familiar with operating, are permitted, are not

permitted to use the unit!

Please keep these operating instructions in a safe place! Too hand over the operating instructions

when passing the unit on to a new owner. Ensure that all work with this unit is only carried out in

accordance with these instructions. The combination of water and electricity can lead to danger to life

and limb, if the unit is incorrectly connected and misused. Only use the unit if no persons are in the

water! Prior to reaching into the water, always disconnect the power supply of all units used in the

water. Compare the electrical values of the power supply with those on the type plate on the packaging

or on the unit itself. Ensure that the unit is fused for a rated residual current of max. 30 mA via a

residual current-operating system. Only operate the unit when plugged into a correctly fitted socket.

Keep the power plug and all connection points dry! Protect the connection cable when burying to avoid

damage. Only use cables, equipment, adapters, extension or connection cables with an earthed

contact and approved for outside use. Do not carry or pull the unit by the connection cable! Never

Technische Änderungen vorbehalten. Für Druckfehler übernehmen wir keine Haftung. 01/2008

FIAP GmbH, Jakob Oswald Str. 16, 92289 Ursensollen

Tel: 09628 9213 0; Fax: 09628 9213 30;