Cisco 3750 - Catalyst EMI Switch Manual de iniciação - Página 7

Procurar online ou descarregar pdf Manual de iniciação para Interruptor Cisco 3750 - Catalyst EMI Switch. Cisco 3750 - Catalyst EMI Switch 27 páginas. Catalyst 3750 series switches
Também para Cisco 3750 - Catalyst EMI Switch: Ficha de dados (18 páginas), Manuais de instalação (47 páginas), Perguntas frequentes (10 páginas), Boletim do produto (5 páginas), Boletim de apoio ao produto (6 páginas), Visão geral do produto (25 páginas), Descrição (1 páginas), Ficha de dados (23 páginas), Boletim de apoio ao produto (6 páginas), Ficha de dados (23 páginas), Manual de iniciação (33 páginas)

(Optional) Enter this information in the Advanced Setting fields:

Step 14

• In the Telnet Access field, click Enable if you are going to use Telnet to manage the

switch by using the command-line interface (CLI). If you enable Telnet access, you

must enter a Telnet password.

• In the Telnet Password field, enter a password. The Telnet password can be from 1 to

25 alphanumeric characters, is case sensitive, allows embedded spaces, but does not

allow spaces at the beginning or end. In the Confirm Telnet Password field, re-enter

the Telnet password.

• In the SNMP field, click Enable to enable Simple Network Management Protocol

(SNMP). Enable SNMP only if you plan to manage switches by using

CiscoWorks 2000 or another SNMP-based network-management system.

• If you enable SNMP, you must enter a community string in the SNMP Read

Community field, the SNMP Write Community field, or both. SNMP community

strings authenticate access to MIB objects. Embedded spaces are not allowed in SNMP

community strings. When you set the SNMP read community, you can access SNMP

information, but you cannot modify it. When you set the SNMP write community, you

can both access and modify SNMP information.

• In the System Contact and System Location fields, enter a contact name and the wiring

closet, floor, or building where the switch is located.

Step 15

(Optional) You can enable Internet Protocol version 6 (IPv6) on the switch. From the

Advanced Settings tab, check the Enable IPv6 check box.

Enabling IPv6 restarts the switch when you complete Express Setup.

Note

To complete Express Setup, click Submit from the Basic Settings or the Advanced Settings

Step 16

tab to save your settings, or click Cancel to clear your settings.

When you click Submit, the switch is configured and exits Express Setup mode. The PC

displays a warning message and tries to connect with the new switch IP address. If you

configured the switch with an IP address that is in a different subnet from the PC,

connectivity between the PC and the switch is lost.

Disconnect the switch from the PC, and install the switch in your production network. See

Step 17

the "Managing the Switch" section for information about configuring and managing the

switch.

If you need to rerun Express Setup, see the "Resetting the Switch" section.