Cisco 3750 - Catalyst EMI Switch Manual de iniciação - Página 19

Procurar online ou descarregar pdf Manual de iniciação para Interruptor Cisco 3750 - Catalyst EMI Switch. Cisco 3750 - Catalyst EMI Switch 33 páginas. Catalyst 3750 series switches
Também para Cisco 3750 - Catalyst EMI Switch: Ficha de dados (18 páginas), Manuais de instalação (47 páginas), Perguntas frequentes (10 páginas), Boletim do produto (5 páginas), Boletim de apoio ao produto (6 páginas), Visão geral do produto (25 páginas), Descrição (1 páginas), Ficha de dados (23 páginas), Boletim de apoio ao produto (6 páginas), Manual de iniciação (27 páginas), Ficha de dados (23 páginas)

Imprimir página

Cisco 3750 - Catalyst EMI Switch Manual de iniciação

Connect to the Switch Ports

This section describes how to connect to the fixed switch ports, the SFP module ports, and the

XENPAK module ports.

Connect to 10/100 and 10/100/1000 Ports

Follow these steps:

When you connect to servers,

Step 1

workstations, IP phones, wireless

access points, and routers, insert a

straight-through, twisted four-pair,

Category 5 cable in a switch 10/100 or

10/100/1000 port.

Use a crossover, twisted four-pair,

Category 5 cable when you connect to

other switches, hubs, or repeaters.

Insert the other cable end into an RJ-45 connector on the other device.

Step 2

The fixed ports on the Catalyst 3750 Power over Ethernet (PoE) switches provide PoE support for

devices that are compliant with IEEE 802.3af, and also provide Cisco pre-standard PoE support for

Cisco IP Phones and Cisco Aironet Access Points.

Each of the Catalyst 3750-24PS switch 10/100 ports or the Catalyst 3750G-24PS switch

10/100/1000 ports can deliver up to 15.4 W of PoE. On the Catalyst 3750-48PS or 3750G-48PS

switches, any 24 of the 48 10/100 or 10/100/1000 ports can deliver 15.4 W of PoE, or any

combination of the ports can deliver an average of 7.7 W of PoE at the same time, up to a maximum

switch power output of 370 W.

By default, a Catalyst 3750 switch PoE port automatically provides power when a valid powered

device is connected to it. For information about configuring and monitoring PoE ports, see the switch

software configuration guide. For information about troubleshooting PoE problems, see the

Catalyst 3750 Switch Hardware Installation Guide on Cisco.com.

The automatic medium-dependent interface crossover (Auto-MDIX) feature is enabled by

Note

default on switches running Cisco IOS Release 12.2(18)SE or later. When the Auto-MDIX

feature is enabled, the switch detects the required cable type for copper Ethernet connections

and configures the interfaces accordingly. Therefore, you can use either a crossover or a

straight-through cable for connections to a copper 10/100, 10/100/1000, or 1000BASE-T SFP

module port on the switch, regardless of the type of device on the other end of the connection.

SY ST

R PS

M A ST R

ST AT

D U PL X

SP EE D

ST AC K

M O D E

10/100 or 10/100/1000 ports

15 X

16 X