Digiplan Portable Folding Chair Manual - Página 4

Procurar online ou descarregar pdf Manual para Mobiliário de interior Digiplan Portable Folding Chair. Digiplan Portable Folding Chair 10 páginas.

Step 4 – Assembly

Please read through the instructions to ensure you have a mental picture of how this chair is constructed.

Remember you may click on underlined words to go directly to the associated picture.

Long Leg Assembly:

Thread a 5/16" hex nut onto one end of the long thread rod and allow approx. 1/8" of thread to stick out

past the nut. Weld this nut to the threaded rod to effectively make a long bolt.

Assemble the 2 long leg tubes, long wrap bar, and long thread rod. With another 5/16" nut, snug the

assembly together just tight enough to still allow some movement.

Clamp the assembly down to ensuring proper orientation to fit the lower long spread bar. Square the

assembly, locate the lower long spread bar and tack it in place.

Flip the assembly over and locate and tack the upper long spread bar. Weld the long spread bars to the leg

tubes. Do not weld the inner joint, as the short leg assembly must fold tight to the inner edge.

Short Leg Assembly:

Weld a 5/16" hex nut to the short thread rod in the same manner as was used for the long thread rod. Bolt

up the assembly and orient it to ensure that the lower short spread bar will lay flush to the table.

Clamp and square the assembly. Keep in mind that this assembly must fit inside the long leg assembly.

Ensure that there is a minimum of 1/32" clearance between the 2 assemblies. You may need to grind down

the short wrap bar and/or the short spread bars.

Once the clearance has been checked, locate the lower short spread bar and tack it in place. Flip the

assembly over, locate and tack the upper short spread bar, then weld them to the leg tubes.

Finishing Up:

Before painting, it is wise to dry fit the chair to ensure fit-up.

Place the short leg assembly into the long leg assembly and bolt them together with the

2 ½" bolts and lock nuts.

Unbolt the threaded rods and remove the wrap bars. If you had the nylon web straps pre-sewn at an

upholstery shop, slip the straps over the wrap bars, and re-fit them into the leg assemblies.

If you choose to sew the straps yourself, lap the ends back to the 4 ¾" mark and sew as shown. It is wise to

melt the cut ends of the straps with a lighter to prevent them from fraying (before you sew them).

Important – Please Read

We cannot be responsible for incorrect construction of this product. Please make sure all welds are strong

before using this climbing stick. Also note these plans are protected under copyright law, unauthorized

reproduction or distribution of these plans is prohibited without written consent from Digiplan

2001/07/08 rev 1.00