Crest Audio CENTURY SERIES TC - TECHNICAL Dados técnicos

Procurar online ou descarregar pdf Dados técnicos para Misturador de música Crest Audio CENTURY SERIES TC - TECHNICAL. Crest Audio CENTURY SERIES TC - TECHNICAL 3 páginas. Century series

Imprimir página

E N T U R Y

E C H N I C A L

FREQUENCY RESPONSE

+0.0, -0.5dB, 20Hz to 20 kHz (referenced to 1kHz)

TOTAL HARMONIC DISTORTION

Mic input to Group output

20Hz to 20 kHz at +15dBu

NOISE

(22Hz to 22kHz)

Mic EIN

Mix Bus Output Noise (20 ch routed)

Aux Bus Output Noise (20 ch routed)

CROSSTALK

(Measured at 1kHz)

Channel Mute

Channel Fader Attenuation

Channel Routing

Channel Aux Send Attenuation

INPUT/OUTPUT IMPEDANCES

Mic Input

Line Input

Outputs

INPUT/OUTPUT LEVELS

Mic Input Sensitivity

Line Input Sensitivity

Input Insertion Point Level

Output Insertion Point Level

Nominal Output Level

Maximum Balanced Output Level

The live sound console shall be constructed in a modular fashion and be housed in a steel frame with molded plastic side panels. The console shall be black with white labeling and utilize XLR lighting

device connectors. The console shall have an XLR talkback mic connector and a headphone jack. These shall be located beneath the far right side of the armrest. All microphone inputs shall be elec-

tronically balanced and accessed via 3-pin XLR connectors and have an EIN of -129 dBu. All line inputs shall be electronically balanced and accessed via 1/4" TRS jacks. The insert points shall be via 1/4"

TRS jacks. Each input channel shall have: a +48 volt phantom power switch, a -15 dB mic pad switch, a 80Hz high pass filter switch, a polarity reverse switch and 4-band (LF-80Hz, LMF-100Hz-2kHz,

HMF-400Hz-8kHz, HF-10kHz) mid-sweepable EQ and an EQ In switch. Each input channel shall also have: a FET controlled (10 millisecond ramp) mute switch with LED, sub-group assignment switch-

es, a L/R assignment switch, a dedicated mono assignment switch, a dynamic signal present LED and peak LED, a PFL switch, and a 100mm long throw fader. Each input channel shall have eight aux-

iliary sends which shall be controlled via six knobs and four switches. The aux sends shall have a pre/post fader switch for every four sends. The aux sends shall be selectable pre or post EQ and pre or

post mute. There shall be an Aux 8 direct switch that shall allow the Aux 8 rotary knob to directly control the output of the 1/4" direct out TRS jack.The console shall be available in four or eight bus

configurations. Each group module shall have a ten-segment LED meter array. The effect return section of each group module shall have a gain control, a two-band fixed EQ, sub-group assignment

switches, a L/R assignment switch, a dedicated mono assignment switch, two aux send controls, a pan control, a level control, a dynamic signal present LED and peak LED, and a PFL switch. The remain-

der of the group module shall have a pan control, a mute switch with LED, assignment switches for: mono and L/R. A PFL switch, dynamic signal present LED and peak LED, and a 100mm long throw

fader shall also be provided on the group module.The master section shall be four modules in width and have the following features: eight aux master controls with associated AFL switches, a 100mm

long throw fader for each of the three master outputs and a comprehensive talkback system. The standard power supply shall be housed in a 14 ga. steel chassis that shall occupy two 19" rack spaces.

The power supply shall have the ability to be daisy-chained to additional power supplies to provide a fail-safe operating environment. Connection of two or more power supplies shall not require addi-

tional interface hardware other than the provided cable. The live sound console shall be: the Crest Consoles Century TC.

Crest Consoles specifications are available in electronic form on our website: http://www.crestaudio.com

Technical Data

P E C I F I C AT I O N S

<0.01%

-129 dBu

-80 dBu

>102 dB

>96 dB

>85 dB

>93 dB

4kΩ balanced

>10kΩ balanced

140Ω balanced

(0VU = +4 dBu, 1.23V RMS)

+4 to -62 dBu

+12 to -38 dBu

+4 dBu

-2 dBu

+4 dBu

+28 dBu

All information per

Crest Consoles Engineering,

May 5, 1997

2.25"/57mm

29.563" / 751mm

Architect's & Engineer's Specifications - Centur y TC

E R I E S

Sheet

Century TC Consoles are available

in the following configurations:

All Century TC Consoles are available with

stereo input modules and matrix modules.

The following table contains net dimensions

for all Century TC consoles. (L x W x H)

Frame Size

Imperial

34" x 29.63" x 9.5"

44" x 29.63" x 9.5"

53" x 29.63" x 9.5"

58" x 29.63" x 9.5"

67" x 29.63" x 9.5"

82" x 29.63" x 9.5"

24.75"/ 717mm

28.0"/ 711mm

O N F I G U R AT I O N S

FOUR SUBGROUP

16, 24, 32, 36, 44, or 56 inputs

EIGHT SUBGROUP

12, 20, 28, 32, 40, or 52 inputs

I M E N S I O N S

Metric

850 x 753 x 241cm

1100 x 753 x 241cm

1350 x 753 x 241cm

1460 x 753 x 241cm

1700 x 753 x 241cm

2070 x 753 x 241cm

2.437"

62mm

9.5"

241mm

Weight

Net lbs./kg

160/72.6

175/79.5

210/95.3

230/104.4

275/124.9

295/133.9