Cisco 9124 - mds multilayer fabric switch Nota de lançamento - Página 12

Procurar online ou descarregar pdf Nota de lançamento para Interruptor Cisco 9124 - mds multilayer fabric switch. Cisco 9124 - mds multilayer fabric switch 22 páginas. Mds 9000 series
Também para Cisco 9124 - mds multilayer fabric switch: Especificações (2 páginas), Ficha de dados (9 páginas), Especificações (3 páginas), Manual de configuração (49 páginas), Nota de lançamento (48 páginas), Nota de lançamento (44 páginas), Nota de lançamento (36 páginas), Nota de lançamento (3 páginas), Nota de lançamento (40 páginas), Manual (16 páginas), Manual de instalação do hardware (36 páginas)

Note: 3

party software management applications may not detect virtual pWWNs

QLOGIC HBAs AND MEZZANINE CARDS CONNECTED TO NPIV-

BASED FIBRE CHANNEL INTERCONNECTS

When using Qlogic HBAs and/or Qlogic mezzanine cards in the following configurations:



Qlogic HBAs connected to the MDS 9124 in NPV mode



Qlogic HBAs connected to the MDS 9134 in NPV mode



Qlogic mezzanine cards connected to the MDS 9124e in NPV mode



Qlogic mezzanine cards connected to the HP Virtual Connect Fibre Channel Module



Qlogic mezzanine cards connected to Brocade in Access Gateway mode

If any of the above are on the same C-series switch and VSAN as its target, NPIV addresses are

limited to 256. To scale beyond 256 addresses, the following C-series switch commands below

must be executed on the VSAN to which NPIV-based FC interconnects are connected.

Note:

If Qlogic HBAs are connected to the same switch and same VSAN as NPIV-based FC

interconnects and the target for the HBA(s) is also on the same switch and the same VSAN, you

must have the minimum driver versions listed below. This includes all Qlogic HBAs and Qlogic

mezzanine cards connected to the desired VSAN.

Miniumum driver versions required:

Windows HBA driver: 9.1.0.11/9.1.0.16

Solaris HBA driver: 4.08

Linux 2.4 kernel HBA driver: 7.07.00

Linux 2.6.14 HBA driver: 8.01.00b6

Netware: 6.80d

VMware ESX HBA driver: 7.07.04

HP-UX HBA driver: latest supported version

Alpha HBA driver: recommend version by storage/switch vendor

HBAs with a Qlogic chipset on the same switch and same VSAN as NPIV-based FC

interconnects are not supported unless the HBA is capable of supporting a common FCID domain

and area as its target. If you are uncertain whether an HBA contains a Qlogic chipset, consult

your storage representative.

Caution:

Implementing the following commands is disruptive and will suspend the VSAN to which NPIV-

based FC interconnects are connected. All devices in the VSAN will momentarily lose

connectivity to the switch. After the VSAN is re-enabled, some devices will acquire a different

FCID. Special consideration must be taken for operating systems and devices requiring persistent

FCIDs.

1. Log into the CLI of the Cisco MDS switch with admin privileges.

2. Execute the following commands for the desired VSAN:

MDS Multilayer Director & Multilayer Fabric Switches Release Notes