Cisco ASR 900 Series Manual de configuração - Página 2
Procurar online ou descarregar pdf Manual de configuração para Interruptor Cisco ASR 900 Series. Cisco ASR 900 Series 6 páginas. Configuring 1g traffic on 8-port 10 gigabit
ethernet interface module
Também para Cisco ASR 900 Series: Manual de configuração (13 páginas), Manual de configuração (19 páginas), Manual de configuração (6 páginas)
Configuring 1G Mode
• 10G mode support on 8x10GE interface module does not change with dual-rate support.
Configuring 1G Mode
Defaulting the Interface Module:
enable
hw-module subslot 0/4 default
end
Changing the Mode:
enable
configure terminal
hw-module subslot 0/4 ether-mode 1G
end
Configuring the Ports:
enable
configure terminal
interface te0/4/0
ip address 63.0.0.1 255.0.0.0
end
Verifying 1G Mode Configuration
The transport mode is LAN (1GB/s). The speed and bandwidth are 1000 Mbps and 1000000 Kbit/sec,
respectively.
To verify the configuration, use show interface command in privileged EXEC mode:
Router#
TenGigabitEthernet0/4/0 is up, line protocol is up
Hardware is A900-IMA8Z, address is c8f9.f98d.2024 (bia c8f9.f98d.2024)
Internet address is 50.0.0.1/8
MTU 1500 bytes, te0/4/0, DLY 10 usec,
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full Duplex, 1000Mbps, link type is auto, media type is SX
output flow-control is off, input flow-control is off
Transport mode LAN (1Gb/s)
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:08:24, output 00:08:24, output hang never
Last clearing of "show interface" counters 00:07:59
Input queue: 0/375/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
.....
To verify the slots configured in 1G mode, use the show running-config | i ether-mode command in privileged
EXEC mode:
Router#
hw-module subslot 0/3 ether-mode 1g
hw-module subslot 0/4 ether-mode 1g
hw-module subslot 0/11 ether-mode 1g
Configuring 1G Traffic on 8-port 10 Gigabit Ethernet Interface Module
2
show interface
tengigabitethernet0/4/0
reliability 255/255, txload 1/255, rxload 1/255
show running-config | i ether-mode
Configuring 1G Traffic on 8-port 10 Gigabit Ethernet Interface Module