Cisco ASR 920 series Manual de instalação - Página 31
Procurar online ou descarregar pdf Manual de instalação para Interruptor Cisco ASR 920 series. Cisco ASR 920 series 42 páginas. Aggregation services router
Também para Cisco ASR 920 series: Manual de instalação (36 páginas), Começar a trabalhar (6 páginas), Manual de instalação do hardware (46 páginas), Manual (36 páginas)
Imprimir página
Installing the Cisco ASR 920 Series Router
DETAILED STEPS
Step 1
Plug the power cord into the power supply.
Step 2
Connect the other end of the power cord to an AC-input power source.
Step 3
Verify power supply operation by checking if the respective power supply front panel LED (PS0 or PS1) is green.
Step 4
If the LEDs indicate a power problem, see
Step 5
If you are connecting a redundant AC power supply, repeat these steps for the second power source.
If you are connecting a redundant AC power supply, ensure that each power supply is connected to a separate
Note
power source in order to prevent power loss in the event of a power failure.
Connect the Chassis to the Network
The following sections describe how to connect a router to the network:
Note
Connect only SELV services to all the router ports.
Connecting Console Cables
The following sections describe how to connect to the router using console cables:
Connecting to the USB Serial Port Using Microsoft Windows
This procedure shows how to connect to the USB serial port using Microsoft Windows.
Install the USB device driver before establishing a physical connection between the router and the PC,
Note
by using the USB console cable plugged into the USB serial port. Otherwise, the connection will fail. For
more information, see the
Before You Begin
SUMMARY STEPS
1. Connect a USB Type A-to-Type A cable to the USB console port, as shown in the figure below. If you
are using the USB serial port for the first time on a Windows-based PC, install the USB driver now
according to the instructions in the following sections:
2. Connect the USB Type A cable to the PC.
3. To communicate with the router, start a terminal emulator application, such as Microsoft Windows
HyperTerminal. This software should be configured with the following parameters:
Chapter 5, "Troubleshooting"
Installing the Cisco USB Device
Cisco ASR 920 Series Aggregation Services Router Hardware Installation Guide
Connect the Chassis to the Network
for troubleshooting information.
Driver.
31