BYOC 10-band graphic equalizer Manual de instruções - Página 13
Procurar online ou descarregar pdf Manual de instruções para Pedal de música BYOC 10-band graphic equalizer. BYOC 10-band graphic equalizer 14 páginas.
Imprimir páginaFinishing Up
Add the enclosure cover and screws and test the pedal. Here are some common problems:
1. No sound at all in either the bypass or on position. If you aren t getting sound in bypass
then you did not wire your footswitch correctly. Getting the bypass to work is the first thing
you need to worry about.
2. Bypass works and the LED lights up when on , but there s no sound. You either have a
problem with the wiring from the in to the out of the circuit board and foot switch. . Or you
have a problem with something on the circuit board.
3. Bypass works, but there s sound when on and the LED does not come on. You probably
aren t getting any power to the circuit. .
The nice thing about this particular pedal is that if you get it to mostly work, it's very easy to
find the problem. If a particular frequency isn't working then you likely have a cold solder
joing on one of the 2 capacitors or slider that affects that frequency. If you notice that the
lower 5 frequencies work but not the upper 5 frequencies, then you likely have a problem with
ICb. If the problem is the opposite, then you likely have a problem with ICa.
If none of this helps, and you can t seem to figure out the problem, I always find that it is best
to just set the pedal aside for a day or 2 and then come back to it with a fresh pair of eyes.
Then the problem usually jumps right out at you .usually.
If you still can t get it working, start a thread on the BYOC forum and ask for help.
board.buildyourownclone.com