BYOC BA6110 Manual de instruções - Página 14

Procurar online ou descarregar pdf Manual de instruções para Pedal de música BYOC BA6110. BYOC BA6110 14 páginas.

Finishing Up

1. Test the pedal to make sure it works properly before you solder the LED.

2. Add all the IC's to their sockets. The DIP8 ICs may have a u-shaped notch. If they do,

match them up with the notch in the socket that should also be matched up with the layout. If

there is no notch, then there should be a small dot in the corner of the IC that denotes pin 1.

Pin 1 on the circuit board will always be denoted by a square solder pad. The SIP9 IC will

have a notch between Pin1 and Pin2 and should be matched up with the line on the layout.

3. Adjust the trim pots as describe earlier.

4. If everything works, unbend the LED leads and guide it into its hole in the enclosure. You

probably don't want to push the LED in as far as it will go. Just push it in far enough so that it

is flush with the outside of the enclosure.

Hold the LED in place and solder it.

5. Put the lid on the enclosure, screw it down, and then apply the self adhesive rubber

bumpers.

If you are having trouble, please visit board.buildyourownclone.com for tech support.