Accustic Arts POWER I you Manual - Página 7

Procurar online ou descarregar pdf Manual para Amplificador Accustic Arts POWER I you. Accustic Arts POWER I you 13 páginas.

5. 7 Correct phase for the loudspeakers

The terminals on your amplifier and your loudspeaker are colour coded or marked with a plus (+) and

minus (-). Connect the red (+) output terminal of your amplifier with the red (+) input terminal of your

loudspeaker. Proceed in the same way with the white (-) terminals.

IMPORTANT!

Avoid short circuits!

Never connect the output terminals of your power amplifier to each other. Neither

connect red (+) with white (-) of the channel nor the channels to each other.

IMPORTANT!

Please observe at all times!

Before you connect the amplifier with some other units using a cable, please never

forget that both units must first be switched off.

5. 8 Replacing damaged mains fuses

If a fuse is damaged only replace the fuse with original types having the same ampere value, the same

voltage endurance and the same time-lag. Never use fuses with other ampere classes or time-lag classes.

IMPORTANT!

Pull out the mains plug!

Always disconnect the unit from the mains power before replacing a fuse.

To change the fuse 2 please use a screwdriver suitable for the slot in the fuse holder. Press the

screwdriver lightly into the slot and gently lever the fuse holder (plastic cap) carefully out of the

respective socket. Now you can take out the fuse holder and replace the fuse.

For countries with 220 - 240 V / 50- 60 Hz

please use the following fuse types:

5 Ampere

time lag

Notice: Use the included fuse for replacement! Use only original parts!

6 How to start the POWER I

The unit can be switched on by pressing the mains power switch POWER and then the left rotary

knob on the front plate.

After switching on the mains power witch the display lights up and the POWER I is ready for use.

For countries with 100 - 120 V / 50- 60 Hz

please use the following fuse types:

10 Ampere

time lag