Cisco Catalyst 2960-CX Manual - Página 22
Procurar online ou descarregar pdf Manual para Interruptor Cisco Catalyst 2960-CX. Cisco Catalyst 2960-CX 24 páginas.
Também para Cisco Catalyst 2960-CX: Visão geral do produto (15 páginas)
Imprimir página
- 1. Table of Contents
- 2. Finding Feature Information
- 3. Prerequisites for Switch Stacks
- 4. Restrictions for Switch Stacks
- 5. Information about Switch Stacks
- 6. How to Configure a Switch Stack
- 7. Troubleshooting the Switch Stack
- 8. Monitoring the Device Stack
- 9. Configuration Examples for Switch Stacks
- 10. Additional References for Switch Stacks
Provisioning a New Member for a Switch Stack: Example
Mac persistency wait time: 7 mins
Switch#
----------------------------------------------------------
*1
Provisioning a New Member for a Switch Stack: Example
This example shows how to provision a switch with a stack member number of 2 for the switch stack. The
show running-config command output shows the interfaces associated with the provisioned switch:
Configuring a Network Port into a Stack Port: Examples
The following example shows how to convert a network port to stack port.
Switch> enable
Switch#configure terminal
Switch(config)#switch 1 hstack-port 1 TenGigabitEthernet 1/0/1
Do you want to continue?[confirm]
New port setting will be effective after next reload
Switch(config)#switch 1 hstack-port 2 TenGigabitEthernet 1/0/2
Do you want to continue?[confirm]
New port setting will be effective after next reload
The following output example shows the status of the port before reload from network port to stack port.
Switch#show switch hstack-ports
Horizontal stack port status :
Te Ports
--------- ------------ -------------------- ------------------- --------------
Te1/0/1
Te1/0/2
The following output example shows the status of the port after reload from network port to stack port.
Switch#show switch hstack-ports
Horizontal stack port status :
Te Ports
--------- ------------ -------------------- ------------------- --------------
Te1/0/1
Te1/0/2
The following example shows how to convert a stack port back to network port.
Switch> enable
Switch#configure terminal
Switch(config)#no switch 1 hstack-port 1
Do you want to continue?[confirm]
New port setting will be effective after next reload
The following output example shows the status of the port before reload from stack port to network port.
Switch#show switch hstack-ports
Horizontal stack port status :
Te Ports
--------- ------------ -------------------- ------------------- --------------
Managing Switch Stacks
22
Role
Mac Address
Priority Version
Master 0016.4727.a900
Stack Port
Operational Status
1
N/W Port
2
N/W Port
Stack Port
Operational Status
1
Stack Port
2
Stack Port
Stack Port
Operational Status
H/W
Current
State
1
P2B
Ready
Next Reload Status
Stack Port
Stack Port
Next Reload Status
Stack Port
Stack Port
Next Reload Status
Managing Switch Stacks
Media Type
Fiber
Fiber
Media Type
Fiber
Fiber
Media Type