Change the printer port from
4
"LPT1" to the network port of the
machine
Change the printer port as follows.
4-1 Click the [Start] button, select [Settings],
and then click [Printers].
4-2 Right-click the SHARP AR-C260 series
printer driver icon, and select [Properties]
from the shortcut menu.
4-3 Click the [Details] tab and then select the
printer port name.
1. Click the IP address of the
The printer port will change from LPT1 to the network port
of the machine.
4-4 Click the [OK] button.
The machine is now connected to your computer
on the network.
To automatically configure the
5
peripheral devices installed on the
machine, install the Printer Status
Monitor from the "Printer Utilities"
CD-ROM. (This can only be used
when the machine is used in a
network environment.)
G To install the Printer Status Monitor, follow
steps 3-1 through 3-4 on page 6 and select the
Printer Status Monitor checkbox in the
package selection screen ("3" on the previous
page).
INSTALLING THE PRINTER DRIVER AND UTILITIES (SOFTWARE INSTALLATION)
machine that appears in
the printer port box.
(Example: 10.36.128.226)
2. Click the "Apply" button.
G Depending on your system, you may need to
restart your computer after installing the Printer
Status Monitor. If a restart message appears,
click the [YES] button to restart your computer.
When the following window appears after
restarting, click the [OK] button.
When your computer starts up
6
normally after installing the Printer
Status Monitor, the Printer Status
Monitor icon ( ) will appear in the
taskbar.
When the Printer Status Monitor is disabled, the
icon is grayed out.
Right-click the installed printer
7
driver and select [Properties
automatically
installed peripheral devices, open
the [Configuration
the [Auto Configuration
This completes the setup procedure.
. To
]
configure
the
tab and click
]
button.
]
7
Imprimir página