Sharp AR-C262M Key Manual de instruções da chave - Página 16
Procurar online ou descarregar pdf Manual de instruções da chave para Impressora tudo em um Sharp AR-C262M Key. Sharp AR-C262M Key 20 páginas. Digital full colour multifunctional system
Também para Sharp AR-C262M Key: Instalação do controlador (28 páginas)
Imprimir página
PROGRAMS FOR COPY MODE
Return from copy mode timing
After printing ends in copy mode, this program is used
to set the amount of time until the mode is changed and
printing begins of a job waiting in printer mode or fax
mode. The amount of time can be set from 0 second to
60 seconds in increments of 1 second.
List print
This program is used to print lists of key operator
programs.
Lists of key operator programs for copier, fax, printer
and network scanner features are available.
Key operator code change
This program is used to change the key operator code.
The key operator must register a key operator code
number and use the number to gain access to key
operator programs. Only one key operator code
number can be registered. The factory has registered
"00000" as the code number to allow initial access to
the programs. It is recommended that the key operator
use the factory number for initial entry into the
programs and then choose and enter another number
by this program.
PROGRAMS FOR COPY MODE
This chapter explains the key operator programs that are used for copy mode.
Copy settings
OTHER FUNCTION SETTINGS
"Other function settings" consists of the following
programs:
GInitial status settings
GExposure adjustment
GRotation copy setting
GAdd or change extra preset ratios
GInitial margin shift setting
GErase width adjustment
GSetting a maximum number of copies
GInitial colour balance setting
GAuto colour calibration
GB/W 600dpi scanning mode for document feeder
14
Product key
Use these programs to input data required to activate
the following systems.
E-mail alert and status
This program cannot be used now. This program is
reserved for future customer support through a
network.
Network scanner expansion kit
This program must be used to activate the network
scanner expansion kit. For the password to be entered,
contact your dealer.
Serial number
Use this program to check the serial number of the
machine. This is necessary to obtain product keys for
"E-mail alert and status" and the Network scanner
expansion kit.
Initial status settings
The copier settings will be reset when the main switch
is turned off, when the [CA] key is pressed, or when the
auto clear interval has elapsed. Use this program to
establish new initial settings or to return the initial
settings to the factory default settings. Paper tray,
exposure mode, copy ratio, duplex mode, and output
mode default settings can be selected.
NOTE
Even if the default state of the two-sided function
has been set to other than one-sided to one-sided
copy mode using this program, in the event that the
two-sided function of the optional duplex module/2
x 500 sheet paper drawer or the reversing
automatic document feeder has failed or has been
prohibited* from use, the default state will revert to
one-sided to one-sided copy mode.
* Disabling of document feeder (page 11)
Disabling of duplex (page 11)
Disabling of inverter (page 11)
Disabling of optional paper drawer (page 11)