Sharp AR-M550N Manual de instruções da chave - Página 12

Procurar online ou descarregar pdf Manual de instruções da chave para Impressora tudo em um Sharp AR-M550N. Sharp AR-M550N 20 páginas. Digital multifunctional system

Imprimir página

GENERAL PROGRAMS

Operation settings

The "Operation settings" are related to basic operation

of the machine and consist of the following programs:

G Keys touch sound

G Auto clear setting

G Disabling of job priority operation

G Message time setting

G Disabling of bypass printing

G Display language setting

G Key operation setting

G Disabling of clock adjustment

Keys touch sound

This program is used to adjust (or turn off) the volume

of the beep that sounds when you touch a key. You can

also have three beeps sound at base values when

setting the ratio in copy mode or adjusting the exposure

in any mode.

KEY OPERATOR PROGRAMS

KEYS TOUCH SOUND

KEY TOUCH SOUND AT INITIAL POINT

Volume: Low

To change the volume, touch the desired volume key.

When "KEY TOUCH SOUND AT INITIAL POINT" is

selected, three beeps will sound at the base setting

values indicated below.

Screen in which setting is

effective

Ratio setting screen in main

screen of copy mode

Exposure adjustment screen in

main screen of copy mode

Exposure adjustment screen in

main screen of fax, Internet fax,

and network scanner modes

Exposure adjustment screen in

[SCAN TO HDD] in main

screen of document filing mode

Auto clear setting

If the machine is not used for a certain duration of time,

the auto clear function will clear any settings that have

been selected and return the screen to the main screen

of copy mode or the job status screen. This program is

used to set the duration of time after which auto clear

operates.The time can be set from 10 seconds to 240

seconds in increments of 10 seconds, or the auto clear

function can be disabled. (Note that auto clear can only

be disabled for copy mode.)

Volume: High

Off

Base value

Ratio = 100%

Exposure level3

(middle level)

Disabling of job priority operation

This program is used to prohibit use of the [PRIORITY]

key in the job status screen.

Message time setting

This program is used to set the length of time that

messages appear in the display (this applies to

messages that appear for a certain length of time and

then automatically disappear.)

The time can be set to as long as 12 seconds in

increments of one second.

Disabling of bypass printing

When a job cannot be printed because there is no

suitable paper and there is a subsequent job that can

be printed, the subsequent job will be printed ahead of

the job that cannot be printed

"Operation manual (general information and copier

operation)"). This program can be used to disable

printing of subsequent jobs in this situation.

*1 Except when paper runs out in the middle of a job

Display language setting

This program is used to select the display language.

Key operation setting

These programs are used to set the length of time a

key in the touch panel must be touched before the key

input is registered, and to prevent repeated key input

when a key is touched continuously.

• Time until key input is registered

The time can be set from 0 seconds to 2 seconds in

increments of 0.5 seconds. Normally the time is set

to 0 seconds so that key input is immediately

registered when a key is touched. By lengthening the

time setting, key input can be prevented when a key

is touched accidentally. Keep in mind, however, that

when a longer setting is selected more care is

required when touching keys to ensure that key input

is registered.

• Prohibit key repeat

The touch panel contains keys such as the zoom

keys (for setting the ratio) that can

continuously to make a value change until it reaches

a desired value.

This feature whereby a value changes continuously

while a key is touched is called key repeat.

Key repeat is normally enabled. If you wish to prohibit

key repeat, select the "DISABLE AUTO KEY

REPEAT" checkbox.

(page 1-14 of the

be touched