Shimano CJ-8S40 Instruções de serviço técnico - Página 5
Procurar online ou descarregar pdf Instruções de serviço técnico para Acessórios para bicicletas Shimano CJ-8S40. Shimano CJ-8S40 5 páginas. Cassette joint
Imprimir página
Adjusting the cassette joint
1.
Set the shifting lever to
4
.
Check to be sure that the yellow setting lines on the
cassette joint bracket and pulley are aligned at this
time.
4
Set to
The yellow setting lines on the cassette joint are
located in two places. Use the one that is easiest
to see.
When bicycle is standing up
Should be straight
Cassette joint bracket
When bicycle is upside down
Should be straight
Cassette joint bracket
If the yellow setting lines are not aligned, turn the
cable adjustment bolt of the shifting lever to align
the setting lines. After this, move the shifting
lever once more from
4
to
4
, and then re-check to be sure that the yellow
setting lines are aligned.
Cable adjustment bolt
2.
After adjusting the cassette joint, cut off the excess
length of inner cable and then install the inner end cap.
15 – 20 mm
Yellow setting lines
These service instructions explain how to use and maintain the
Shimano bicycle parts which have been used on your new
bicycle. For any questions regarding your bicycle or other
matters which are not related to Shimano parts‚ please contact
the place of purchase or the bicycle manufacturer.
These service instructions are printed on recycled paper.
Please note: Specifications are subject to change for improvement without
Cassette joint
notice. (English)
pulley
CJ-8S40
JAPAN
One Holland Irvine CA 92618 U.S. A. Phone 949- 95 1- 500 3
Industrieweg 24 NL- 8 07 1 CT Nunspeet‚ Holland Phone 31 - 3 41 -2 7 222 2
3 -77 Oimatsucho‚ Sakai‚ Osaka‚ Japan Phone 07 2 -22 3 -3 243
Mar. 2003 by Shimano Inc. PIT. SZK. Printed in Japan
C
Cassette joint
pulley
1
and then back to
Inner end cap
CJ-8S40
JAPAN
t