Digital Audio Labs Livemix MT-1 Manual do utilizador - Página 2

Procurar online ou descarregar pdf Manual do utilizador para Racks & Stands Digital Audio Labs Livemix MT-1. Digital Audio Labs Livemix MT-1 2 páginas. Pole mount

Imprimir página

THREAD MOUNT

Before you begin, locate these parts of the MT-1:

1. Large circle opening on the bottom side of the

mount

2. 1x 5/8" - 27 nut (secured to MT-1 with V-Clamp

screw.

3. 2x Captive thumbscrews (thread into personal

mixer)

To attach the MT-1 and CS-DUO or CS-SOLO to

your mic stand:

1. Align the large circle opening on the bottom side of the

MT-1 with the top of the microphone stand.

2. Secure the MT-1 by threading the 5/8" - 27 nut until it is

finger tight.

3. To firmly lock the MT-1 in place, hold the microphone

stand pole with one hand while turning the MT-1 with the

other hand.

4. Locate the two captive thread holes on the bottom side

of the personal mixer that are closest to the front panel.

These are the recommended mounting connections on

the CS-DUO or CS-SOLO for this configuration.

5. While holding the CS-DUO or CS-SOLO, align the MT-1

captive thumbscrews with the personal mixer captive

thread holes mentioned in step 4.

6. Still holding the personal mixer, thread the thumbscrews

into the mixer by hand. If permanent attachment is desired, the thumbscrews can also

accommodate Flathead and Phillips screwdrivers.

7. Route cables through cable management openings.

The mic stand thread mount configuration allows a CS-

DUO or CS-SOLO to mount on a dedicated microphone

stand. This mounting method is perfect for musicians that

don't require other stands for microphones or music.

Four captive thread holes on the bottom side of the

CS-DUO or CS-SOLO allow the personal mixer to mount

in two different positions on the MT-1.

1266 Park Road

Chanhassen, MN 55317

952-401-7700

[email protected]