Accutone WT88 Manual de instalação e manual do utilizador - Página 5

Procurar online ou descarregar pdf Manual de instalação e manual do utilizador para Auscultadores Accutone WT88. Accutone WT88 8 páginas. Wireless telephone headset

Imprimir página

B. INSTALLING YOUR WT88 HEADSET

Installation

B5. installing the handset lifter (optional)

external sensor

The lifter has a built-in ring sensor that picks

up the ringing sound from a call and sends a

beep sound to the wireless headset. If your

telephone ring's volume is too low, or if the

ring sound is generated from another

location, you can use the external sensor, by

plugging it to the bottom of the lifter.

turn clockwise

for higher

sensitivity

putting everything together!

Flip over the handset lifter, you will find

two stickers placed perpendicularly.

Carefully remove the sticker seals and

place the lifter on top of the telephone

speaker area (as shown below) of the

telephone under the handset.

Connect the Lifter Plug (W) into the

Lifter Connector (K) located at the back

of the base station (the right-most jack).

Adjust the ring sensor's sensitivity by

turning (R) clockwise for increasing

sensitivity. The lifting height for the lifter

can be adjusted by switching (S) to the

topmost for the highest uplift.

The LED Indicator (T) lights up when you

press the Answer Button (3) on your

headset, indicating online status.

B6. pairing the wireless headset with your telephone

Different telephones have different settings, so

in some cases you will have to pair your

wireless headset with your specific telephone.

To see whether you need further adjustments,

put on your headset (after you have completed

all the steps listed in section B so far), press the

Answer Button (3) on your headset for the

lifter to uplift the handset, or manually pick up

the handset if you don't have a lifter.

If you hear a dial tone, the wireless headset is already compatible with your

telephone. But if you do not hear a dial tone, pair up the two by sliding the

Compatibility Switch (P) and you should be able to hear a dial tone.

B7. setting the microphone type and gain level

Make a call with your wireless headset, if the

other side cannot hear you or the sound is

very small, select the Microphone Selection

Switch (O) from "E" to "C".

If the other side can now hear you, but the

sound is still not optimal, you can adjust this

via the Microphone Gain Dial (Q) to the

desired level. This gain level is a pairing of the

microphone with the telephone, this is not a

turn clockwise

volume setting, so once setup, you will not

for increasing

microphone gain

need to adjust this gain level again.

[ inspiring people, inspiring change ]

Installation