Digital Blue QX3 Manual de configuração - Página 6
Procurar online ou descarregar pdf Manual de configuração para Microscópio Digital Blue QX3. Digital Blue QX3 8 páginas. Computer microscope
Também para Digital Blue QX3: Manual do utilizador (16 páginas)
Imprimir página1318 Parent Guide Final
03/12/2002
Care and maintenance
Lens cover
Caring
for the lens
replacement
cover
If the lens cover becomes severely
smudged, scratched, or stained, it
The protective lens
should be replaced. To order a
cover on the QX3
™
replacement lens cover, see
microscope may
"Support" on page 7.
become dirty with
use. Use only
Step 1
canned air to clean
The cover is
it. Never use a lens
replaced by
brush or other
removing the two
rubbing method to
Phillips head screws
clean the lens cover.
and discarding the
Avoid the use of
damaged cover.
liquid cleaners!
Step 2
Cleaning the
Secure the replacement cover with
sample plat-
the retained Phillips head screws. Do
form
not over-tighten.
The sample platform
Changing bulbs
should be wiped
clean with a damp
Bulbs used in the QX3
cloth after use. The
a special type not found in stores.
stand and
Replacement bulbs other than
microscope should
authorized Digital Blue bulbs may
also be wiped clean
cause damage to your microscope and
whenever required.
void your warranty! To order
replacement bulbs, see "Support" on
page 7.
NOTE:
whenever there is a noticeable
decrease in light output. Adequate light
is needed to get the best capture with
the microscope.
6
04:05 PM
Page 6
™
microscope are
A bulb should be replaced
IMPORTANT:
The bulbs
become hot when operating. Make
sure the bulb has fully cooled to room
temperature before replacing. Do not
touch the surface of the replacement
bulb with your fingers.
Use a cloth or cotton
glove to prevent
damage to the bulb.
To change bulbs, follow
these steps:
Upper bulb replacement
1. Unplug the USB cable from your
computer.
2. Remove the microscope from
the base.
3. Remove the single screw holding
the bulb retainer in the microscope
housing.
4. Remove and discard the old bulb.
5. Insert the new
bulb, replace
the bulb retainer
and re-attach
the USB cable.
Lower bulb replacement
1. Unplug the USB cable from
your computer.
2. Remove the microscope from the
base and set it aside.
3. Remove the bulb cover on the
bottom of the sample platform by
loosening two screws.
4. Remove and discard
the old bulb.
5. Insert the new bulb,
replace the bulb
cover and re-attach
the USB cable.
IMPORTANT:
All procedures on this
page must be performed
by an adult.