Digital Control DigiTrak Falcon F1 Manual de início rápido

Procurar online ou descarregar pdf Manual de início rápido para Equipamento industrial Digital Control DigiTrak Falcon F1. Digital Control DigiTrak Falcon F1 6 páginas.

Imprimir página

Power On the Locator

Install the battery pack and hold

the trigger for one second.

Click to acknowledge the warning.

Click twice to open the Main menu.

Main Menu

To open the Main menu from the Locate Mode screen, click the

trigger. Click to move through the menu and screens. Hold the

trigger briefly and release to make a selection. Power Off is on the

next screen. After 6 seconds idle, the screen returns to Locate

Mode.

Steps Required Before Drilling

1. Optimize and Measure Active Interference

The FO scans 60+ frequencies and selects the quietest frequencies

to optimize the signal for band 11.

There are two methods to optimize frequency bands:

Pair

Scan, Pick, and Pair

and

visually inspect entire site for sources of interference, such as

traffic loops and other utilities.

the deepest part of the bore for sources of interference

Basic Method: Quick Scan Pair (QSP)

At jobsites with minimum active interference, optimize band 11. The

locator does not display noise during QSP optimization.

With the Tx off, go to the spot on the bore path with highest

suspected interference or the deepest part of the bore.

1. Telemetry channel

2. Transmitter (Tx) band down

3. Tx Power Mode (left)

Locator battery strength (right)

4. Frequency Optimization (FO)

5. Tx Quick Scan Pair (QSP)

6. Calibration

7. HAG and TrakStand

8. Settings

9. Target depth (displays when set)

10. Target Steering

. To decide which method to use,

Pay attention to the area around

1. IR port

2. Trigger

Quick Scan

digital-control.com

- 1 -