Digital deep sea NMEA 0183 Manual do produto - Página 2
Procurar online ou descarregar pdf Manual do produto para Equipamento marítimo Digital deep sea NMEA 0183. Digital deep sea NMEA 0183 13 páginas. 3g/4g router
Imprimir página
1. Introduction
Congratulations on the purchase of your 4GXtream 3G/4G Router. This unit is designed for permanent installation on
board a sail or motor boat. The 4GXtream comprises of the following parts;
•
4GXtream Router/Modem unit
•
2x internal Wi-Fi antenna
•
2x External LTE antennas, 7m Cables and Mounts
•
1x GPS Antenna
•
1x Power Cable
•
User Manual
Before operating 4GXtream you should familiarise yourself with this User Manual and the manuals for
any other equipment you wish to connect to it.
2. Before you start
The 4GXtream is configured and controlled via its built-in web interface. In order to access this, you will need a wireless
device such as a PC/Mac, Tablet or Smart Phone running a modern web browser such as Chrome, Safari, Edge or
Firefox. No special drivers or software are required to make the 4GXtream work.
Do not plug in the 4GXtream to the Ethernet port of your computer whilst the 4GXtream is powered up
and always ensure that the 4GXtream antennas are connected before powering up the 4GXtream.
3. Installation
The 4GXtream is designed to be mounted below deck. When deciding on the best location, a central location will give
best Wi-Fi reception in all areas of the boat. You should also consider the 7m coax cable length of the external 3G/4G
Antennas, which should not be extended. It is better to locate the 4GXtream unit within the 7m limit of the supplied 3G/4G
antenna cables, and then use a wireless repeater if Wi-Fi reception is poor in some areas of the vessel.
If the 3G/4G antenna cable run is a problem, Digital Deep Sea can supply 10m or 20m antenna cables, but these are
larger and more expensive LMR400 cables (10.5mm Diameter) which must be purchased separately.
The power cable can be easily extended, as can the LAN/WAN Ethernet cables.
The default settings of the 4GXtream have been chosen for optimum performance and we do not
recommend users make any changes to them, except to change the default wireless network name (SSID)
and wireless password.
3.1
Mounting the 4GXtream
The 4GXtream should be mounted in position using M4 screws or other fixings appropriate to the mounting location. It
can be mounted in any orientation, as the Wi-Fi antennas can be rotated and bent for best reception, although we
recommend mounting the 4GXtream vertically with the antennas pointing upwards, to avoid stress on the cables and to
ensure any moisture/condensation falls away from the connectors.
On the next page (Fig.1) is a dimensioned drawing of the 4GXtream. When rotating the supplied Wi-Fi antennas, always
rotate them clockwise to avoid loosening them. Make sure you allow suitable space around the top and bottom of the unit,
to comfortably route the cables (avoiding tight bends) and to secure them so that the weight of the cables is not just being
taken by the cable connectors.
TEL + 44 1179 554474 www.digitalyacht.co.uk
Product Handbook for 4GXtream V1.00