DIGITAL DELAY Elite RPM Manual - Página 3

Procurar online ou descarregar pdf Manual para Interruptor DIGITAL DELAY Elite RPM. DIGITAL DELAY Elite RPM 5 páginas.

SHIFT:

Connect the Shift terminal to the shift solenoid.

IGN:

Connect the Ignition terminal to the wire that turns your ignition on/off.

+12V:

Connect the +12V terminal to 12 Volt source capable of supplying enough current for the shift solenoid.

GND:

Connect the Ground terminal to the Neg. terminal on the battery or to a good steel ground, not aluminum.

TACH:

Connect the Tach terminal to the Tach output on the ignition. The Tach terminal must be connected

for proper operation of the unit.

The Setup screens allow the Elite RPM Switch to be configured to best meet your needs. There are three

Setup settings that need to be set before the Elite RPM Switch can be used. Once set, these values should not need to

be adjusted unless a change is made to the vehicle setup. The Setup values can only be changed when the engine

RPM is below 2,000 RPM or off. To enter Setup, press and hold the Select Shift button until the top LED starts

flashing. The Shift Pulse is displayed first, to move to Shift Mode or Number of Cylinders, press the Select Shift

button again. The flashing LED will move each time the Select Shift button is pressed. Use the Change Number

buttons to adjust the values. To exit Setup once all the values have been set, press and hold the Select Shift button

until the LED stop flashing. Additionally the Elite RPM Switch will automatically exit Setup after ten seconds if no

button is pressed.

Note: The LEDs flash only when the Elite RPM Switch is in Setup.

The Shift Pulse Time is the amount of time the Shift output is activated for when the set shift RPM is

reached. The Shift Pulse time can be set from .20 to .99 seconds.

To set the Shift Pulse Time, press and hold the Select Shift button until the top LED is flashing. Then use the

Change Number buttons to set the desired Shift Pulse Time.

The Shift Mode setting is used to select whether the Shift Output will supply +12 Volts or Remove +12 Volts

when the shift point is reached. A setting of "01" means the Elite RPM Switch will supply +12 Volts. While a setting

of setting of "00" will remove +12 Volts.

To set the Shift Mode, press and hold the Select Shift button until the top LED is flashing. Then use the

Select Shift button until the second LED is flashing. Then use a Change Number button to set the desired Shift Mode.

The Number of Cylinders setting is used by the Elite RPM Switch to calculate engine RPM. Therefore it

must be set correctly for proper operation of the unit.

To set the Number of Cylinders, press and hold the Select Shift button until the top LED is flashing. Then

use the Select Shift button until the third LED is flashing. Then use a Change Number button to set the desired

Number of Cylinders.

Note: Cylinder settings of 4, 6, and 8 are available.

2036 Fillmore Street, Davenport, Ia. 52804

563-324-1046

The Terminal Strip

Initial Setup

Shift Pulse Time

Number of Cylinders