BitRage CR45-A-58 Manual de instalação e configuração - Página 9

Procurar online ou descarregar pdf Manual de instalação e configuração para Transcetor BitRage CR45-A-58. BitRage CR45-A-58 12 páginas.

Additional

Responsibilities

Installation

Checklist

Installation and

Verification

Procedures

xxxxx, Ver 0.01

In addition to meeting these requirements, the antenna system installer is

responsible for installing antennas so that they comply with FCC RF

exposure requirements. The FCC RF exposure requirements at a given

location are based on the sum total of contributions from all radio sources.

For BitRage antennas placed in close proximity to other transmitters,

installers must ensure that MPE guidelines in 1.1307 of the FCC Rules can

still be met, after including the contribution from the new antenna. Further

information and guidance is available in FCC Bulletin OET 65,

www.fcc.gov/oet/rfsafety.

Persons operating the equipment must ensure that it does not cause

interference. Specifications must be followed for any special cables (for

example, shielded cables) that are required for the unit to meet the EMC

standards to which compliance is declared.

The user must not make any modifications to the unit, unless expressly

approved by the party responsible for compliance. Failure to comply with

this rule could void the user's authority to operate the equipment.

[to be added]

After the antenna dish has been installed, follow these procedures to connect

radio:

1. Attach the radio on a permanent position within the reach of the R.F.

cable that connects between the radio and antenna.

2. Connect the R.F. cable between the radio and antenna.

3. Route the RX, TX, and POWER cables from the radio to the termination

point.

4. Connect the RX, TX, and POWER cables to the radio.

5. Secure the POWER SUPPLY unit at a desired location. Do not connect

the AC cable at this time.

6. Connect the RX, TX, and POWER cables to the POWER SUPPLY unit.

7. Connect the I/O data cables between the application device and POWER

SUPPLY unit. Application devices must generate and accept the DS-3

specified signals.

Installing the Equipment

1–3