Samsung A3LSMN915KOR Manual do utilizador - Página 7

Procurar online ou descarregar pdf Manual do utilizador para Telemóvel Samsung A3LSMN915KOR. Samsung A3LSMN915KOR 39 páginas.

Imprimir página

Health and safety information

Exposure to Radio Frequency (RF) Signals

Certification Information (SAR)

Your wireless phone is a radio transmitter and receiver. It is designed and

manufactured not to exceed the exposure limits for radio frequency (RF) energy set

by the Federal Communications Commission (FCC) of the U.S. government. These

FCC exposure limits are derived from the recommendations of two expert

organizations, the National Counsel on Radiation Protection and Measurement

(NCRP) and the Institute of Electrical and Electronics Engineers (IEEE). In both

cases, the recommendations were developed by scientific and engineering experts

drawn from industry, government, and academia after extensive reviews of the

scientific literature related to the biological effects of RF energy.

The exposure limit set by the FCC for wireless mobile phones employs a unit of

measurement known as the Specific Absorption Rate (SAR). The SAR is a measure

of the rate of absorption of RF energy by the human body expressed in units of watts

per kilogram (W/kg). The FCC requires wireless phones to comply with a safety limit

of 1.6 watts per kilogram (1.6 W/ kg). The FCC exposure limit incorporates a

substantial margin of safety to give additional protection to the public and to account

for any variations in measurements.

SAR tests are conducted using standard operating positions accepted by the FCC

with the phone transmitting at its highest certified power level in all tested frequency

bands. Although the SAR is determined at the highest certified power level, the

actual SAR level of the phone while operating can be well below the maximum value.

This is because the phone is designed to operate at multiple power levels so as to

use only the power required to reach the network. In general, the closer you are to a

wireless base station antenna, the lower the power output.

Before a new model phone is available for sale to the public, it must be tested and

certified to the FCC that it does not exceed the exposure limit established by the

FCC. Tests for each model phone are performed in positions and locations (e.g. at

the ear and worn on the body) as required by the FCC.

For body worn operation, this model phone has been tested and meets the FCC RF

exposure guidelines when used with a Samsung accessory designated for this

product or when used with an accessory that contains no metal and that positions

the handset a minimum of 1.0 cm from the body.

Non-compliance with the above restrictions may result in violation of FCC RF

exposure guidelines.

SAR information on this and other model phones can be viewed on-line at

http://www.fcc.gov/oet/ea/fccid/.

Please use the phone FCC ID number for search,

A3LSMN915KOR.

Sometimes it may be necessary to remove the battery pack to

find the number. Once you have the FCC ID number for a particular phone, follow

the instructions on the website and it should provide values for typical or maximum

SAR for a particular phone. Additional product specific SAR information can also be

obtained at

http://www.fcc.gov/encyclopedia/specific-absorption-rate-sar-cellular-telephones

Consumer Information on Wireless Phones