Samsung Anycall SGH-N700 Manual de serviço - Página 6
Procurar online ou descarregar pdf Manual de serviço para Telemóvel Samsung Anycall SGH-N700. Samsung Anycall SGH-N700 36 páginas. Samsung mobile phone service manual
Circuit Description
2) TX PART
Baseband IQ signal fed into offset PLL, this function is included inside of U404 chip.
SI4205 chip generates modulator signal which power level is about 1.5dBm and fed into Power Amplifier(U403).
The PA output power and power ramping are well controlled by Auto Power Control circuit. We use offset PLL below
Modulation Spectrum
2. Baseband Circuit description of SGH-N700
1) CSP2200B1
1. Power Management
Seven low-dropout regulators designed specifically for GSM applications power the terminal and help ensure optimal
system performance and long battery life. A programmable LDO provides support for 1.8V, 3.0V SIMs, while a
self-resetting, electronically fused switch supplies power to external accessories. Ancillary support functions, such as two
LED drivers and two call-alert drivers, aid in reducing both board area and system complexity. A four-wire serial interface
unit(SIU) provides access to control and configuration registers. This interface gives a microprocessor full control of the
CSP2200B1 and enables system designers to maximize both standby and talk times. Error reporting is provided via an
interrupt signal and status register. Supervisory functions. including a reset generator, an input voltage monitor, and a
thermal monitor, support reliable system design. These functions work together to ensure proper system behavior during
start-up or in the event of a fault condition(low microprocessor voltage, insufficient battery energy, or excessive die
temperature).
2. Battery Charge Management
A battery charge management block, incorporating an internal PMOS switch, and an 8-bit ADC, provides fast, efficient
charging of single-cell Li-Ion battery. Used in conjunction with a current-limited voltage source, this block safely
conditions near-dead cells and provides the option of having fast-charge and top-off controlled internally or by the system's
microprocessor.
3. Backlight LED Driver
The backlight LED driver is a low-side, programmable current source designed to control the brightness of the keyboard
illumination. LED1_DRV is controlled via LED1_[0:2] and can be programmed to sink from 15mA to 60mA in 7.5mA
steps. LED2_DRV is controlled via LED2_[0:2] and can be programmed to sink from 5mA to 40mA in 5mA steps.
200kHz offset
30 kHz bandwidth
400kHz offset
30 kHz bandwidth
600kHz ~ 1.8MHz offset
30 kHz bandwidth
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
GSM
DCS
GSM
DCS
GSM
DCS
2- 2
-35dBc
-35dBc
-66dBc
-65dBc
-75dBc
-68dBc