Siemens SIMATIC NET Manual de instalação - Página 21

Procurar online ou descarregar pdf Manual de instalação para Equipamento industrial Siemens SIMATIC NET. Siemens SIMATIC NET 48 páginas. Network components bus terminal
Também para Siemens SIMATIC NET: Manual de Instruções (29 páginas), Manual de Instruções (50 páginas), Manual de Instruções (28 páginas), Manual de instruções de montagem (6 páginas), Informações sobre o produto (6 páginas), Manual de instalação (40 páginas), Manual de instalação (50 páginas), Manual de instalação (40 páginas), Manual de referência (14 páginas), Manual de instalação (34 páginas), Manual de Instruções (32 páginas)

Installing the Device

2.5 Connecting Power

Figure 2.3

2.5

Connecting Power

The RUGGEDCOM M2100F supports a single or dual redundant AC and/or DC power

supplies.

The RUGGEDCOM M2100F can be equipped with either a screw-type or pluggable

terminal block, which provides power to both power supplies. The screw-type

terminal block is installed using Phillips screws and compression plates, allowing

either bare wire connections or crimped terminal lugs. Use #6 size ring lugs for

secure, reliable connections under severe shock or vibration.

Electrical hazard – risk of damage to the device

Make sure power input to the device is within the specified input range. For

information about the nominal input range for the device, refer to

Specifications (Page

Note

•

Normally Open

Common

Normally Closed

Failsafe Alarm Relay Wiring

NOTICE

25)".

For maximum redundancy in a dual power supply configuration, use two

independent power sources.

Use minimum #16 gage copper wiring when connecting terminal blocks.

For 100-240 VAC rated equipment, an appropriately rated AC circuit breaker

must be installed.

A circuit breaker is not required for 12, 24 or 48 VDC rated power supplies.

It is recommended to provide a separate circuit breaker for each power supply

module.

"Power Supply

RUGGEDCOM M2100F

Installation Manual, 04/2022, C79000-G8976-1342-09