Siemens SIMATIC TP1200 Comfort INOX PCT Instruções de funcionamento do Compact - Página 24
Procurar online ou descarregar pdf Instruções de funcionamento do Compact para Equipamento industrial Siemens SIMATIC TP1200 Comfort INOX PCT. Siemens SIMATIC TP1200 Comfort INOX PCT 48 páginas. Hmi devices; comfort panels
Também para Siemens SIMATIC TP1200 Comfort INOX PCT: Instruções de funcionamento do Compact (42 páginas)
Imprimir página
Mounting the device
3.3 Mounting the device
3. Insert the mounting seal into the stainless steel front as shown. Also note points
④
⑤
⑥
Similar to figure
4. Check the correct fit of the mounting seal:
– The coding tap is placed at the specified location.
– All positioning hooks rest flush in their cutouts. The mounting seal is installed correctly
– The edge of the mounting seal is flush with the edge of the stainless steel front all
3.3
Mounting the device
The following figures in this section are examples.
Requirement
● All packaging components and the edge protection tape, if present, have been removed.
● 1 clamping frame
● Fasteners:
– TP900 Comfort INOX PCT: 13 mounting clips
– TP1200 Comfort INOX PCT: 12 mounting clips
Observe the additional product information, if any, supplied with the product.
Mounting
Risk of injury when device falls
An unsecured device may fall. This can result in personal injury or damage to machines
and the device.
Secure the device against dropping during the entire installation.
24
Seal corner is underneath the housing frame.
The positioning hook of the seal fully engages into the cut-out, flat without protrusion.
The coding key lies flat in the intended cut-out.
when it lies flat on the entire stainless steel front. This must not lead to distortions and
protrusions.
If necessary, correct the seat: To do this, press the mounting seal into the recess.
around.
CAUTION
Compact Operating Instructions, 05/2018, A5E38804191-AA
④
⑥
-
.
Comfort Panels INOX PCT