Siemens TS1 Manual - Página 2

Procurar online ou descarregar pdf Manual para Equipamento industrial Siemens TS1. Siemens TS1 2 páginas. Push button

Step 7

Once the bearing is in position feed the blank bur up

into the bearing ram on the right side of the press. Slowly

pull down on the handle while holding the turbine in

place until the rear of the spindle meets and is aligned

with the hole in the center of Insert #1. Gently press

bearing down the spindle until it stops at Insert #1. If the

bearing is riding loosely on the spindle use EZ Tight to

hold it on.

Step 9

Locate the front bearing and drop it over the bur so

the silver shielded side faces up and the black side

faces down towards the impeller. Repeat pressing

process until bearing comes to a stop when it reaches

the impeller. If the bearing is riding loosely on the spindle

use EZ Tight to hold it on.

Step 11

If the headcap heats up or you feel resistance while

testing remove the turbine and re-inspect the head

with an explorer to make sure no debris was overlooked.

If clean then call for Tech Support.

Step 8

Locate the impeller and repeat process, making sure that

with the bur facing away from you the air would turn the

impeller clockwise or the blades slant left at the 12 o'clock

position. Press impeller until it stops at the bearing.

Step 10

Using an explorer remove the old o-rings from the head

and head cap. Clean the head and head cap with

cleaner and a cotton swab, making sure to remove any

debris. Use your explorer to install the new o-rings into the

head and head cap. Seat the rebuilt turbine into the head

cap and install into head. Tighten cap down completely

and make sure the bur rotates and releases the bur, then

hook up and run.

REPDGM/SM002-Rev A-4/24/2006